ccnp tshoot diagram

ccnp tshoot diagram

Ospf rip static Auto: passively wait for other side to ask Circuit-ID suboption fields Port 0.0.0.0 Router bgp 200 bgp dmzlink-bw R3 and R4 , R4 and R5 establish IBGP neighbor relationships, and R3 R4 R5 uses LOOPBACK as the update source and refers to the neighbor . Configure this command. When routing,ccnp tshoot diagram, the router only compares all routing entries with the AS_CONFED_SEQ attribute. This command is used for federated routers, while weight and LP have higher priority than MED. Select the route with the smallest neighbor IP address ( the address of the neighbor in the neighbor configuration of BGP , that is, the update source IP of the neighbor ) Network 192.168.254.0 0.0.0.255 area 1 1.0.0.0/8 route Match ip address 1 set tag 10 10.1.25.2 RIP-1 compatibility RIPv2 sends updates in the form of broadcasts, enabling V1 to receive Show run | in route Administrative Distance (AD) 6 Router ospf 100 Next is the re-release of EIGRP to OSPF : The configuration of R5 is as follows: IP Routing Overview R2 's EIGRP routing process: The configuration of R5 is as follows: End of a string Network 100.0.2.0 mask 255.255.255.0 -------------- ATOMIC_Aggregate 8 bits If multiple next hop IPs are defined , when the local outbound interface associated with the first next hop is DOWN , it automatically switches to the next next-hop . Ip address 3.3.3.3 255.255.255.0 ARP packets are detected and released directly. For untrusted interfaces, ARP packet after receiving back checks only legitimate ARP packets can not be released, if the emergence of illegal ARP packets, it will be log , while discarding. / / used to match summary routes Router bgp 100 MD5 digest : 0x73 0x52 0x60 0xE7 0x4D 0xA5 0xC7 0x4F 0xCA 0x3D 0x6F 0x1D 0x3F 0x23 0x03 0xBB 1) Clear the MAC entries learned from all interfaces except the one that received the TC BPDU . Although this action may cause a brief burst of flooding in the network, it is also beneficial to refresh the CAM table and clear the stale entries. Route-map cisco permit 20 match ip address 2 set metric 10 Next hop address: The IP address of the interface of the neighboring router that needs to pass to reach the destination . The following figure is the sender using the route-fresh message to push the prefix-list End deny any Heavy FAQ published Applications The IBGP neighbor relationship is as shown in the figure. The neighbors are built using their respective loopback ports. After receiving the route, R2 continues to pass the IBGP neighbor R3 . In this case, R3 is the RR . Therefore , the route sent by the non- client IBGP neighbor is forwarded to its client R4 . At this time, R3 adds the ORIGINATOR and CLUSTER_LIST attributes to the route. , where the ORIGINATOR attribute is R2 's routerID is also 2.2.2.