ccie rs lab blueprint

ccie rs lab blueprint

speed auto Now look at the main and standby engines of the SS0 mode. Normally this should be the case. interface Ethernet0/1 As can be seen from the above, the FO configuration is successful and a master-lave mode is formed. In progress to Issu negotiation la This is in sync. Under normal circumstances, you can go to Standby hot mode. SPU7 requires IPBASE SUP7LE Requires Enterprise Base When the flow of outside traffic enters the interior, it is sometimes necessary to isolate an area, such as a security room. This is equivalent to the DMZ area of the monthly server. Mainly to provide a service for the outside. If the server is attacked, then the attacker still can not Going inside the security zone. The concept of sub-regions can solve security problems well. There is also a change of 0X2102. This is very simple so not too much to say. ASA’s infrastructure This is the firewall that uses the ACL to write to the OUTSIDE interface to release external traffic into the internal. And to monitor this traffic in real time. This is what we often say based on the adaptive algorithm-based state monitoring packet filtering firewall. It is also the most mainstream firewall mainly Cisco ASA, JUNIPER firewall. CISCO’s strong performance leadership world As can be seen from the above, the FO configuration is successful and a master-lave mode is formed. network 10.1.1.1 0.0.0.0 area 0 access-list 100 deny ip 192.168.10.0 0.0.0.255 192.168.30.0 0.0.0.255 failover polltime interface 1 holdtime 5 access-list 101 permit ip any any failover link state Ethernet0/3 no aaa new-model 4507B#sh module failover mac address Ethernet0/1 0018.1900.4000 0018.1900.4001 access-list 101 deny ip 192.168.20.0 0.0.0.255 192.168.30.0 0.0.0.255 Question 1: The customer now needs to be able to access each other between the network segments but can be connected to the public network. ISBL's 2 cores 6509 do VSS, OSBL's 2 cores 6509 do VSS. Installing licenses from "bootflash:F〇X1509GTJU_20111127185652223.lic" The model must be selected before you can choose the next step. 4507B#license install usb0:/FXS1941Q21T_201605030017404860.lic This command can upgrade the standby engine's IOS to the primary engine. int Ethernet0/1 interface Vlan10 interface Vlan20 Now you can do NAT conversion. There are two main steps to do NAT conversion. The first step is to specify the scope of a conversion. What does it mean? It is possible that there are many network segments on the intranet,ccie rs lab blueprint, not every network segment. Public network, some companies require that only part of it can go to the public network. Part of it cannot be on the public network, such as protecting the security of some data and so on. Because ISP now only assigns an IP address to you so do port address translation. This port is the configured OUTSIDE interface.