ccnp route exam practice

ccnp route exam practice

The length of the AS_PATH is to influence the path selection. It is not recommended in the actual environment. Matches the preceding character 0 times or 1 occurrences Configure the primary VLAN to associate the Layer 2 secondary VLAN to the primary VLAN. Load balancing can be modified on AVG , but it is recommended to configure on all routers. We found that both routes are best and are loaded into the routing table. No-advertise It means for VLAN100 traffic, not to log the ARP ACL discarded packets match Type of data. For example, change the COMM value of a route of AS12 to 10000 , and the RFC uses hexadecimal to indicate the COMMUNITY attribute, while CISCO In general, we believe that the attack behavior is mostly from the terminal's PC , which may be poisoning or hacking. Therefore , the interface connected to the terminal PC is configured as a DAI untrust interface, and the interface between the switches is configured as a trust interface. The configuration of R3 is as follows: BVI Bridge-Group Virtual Interface Distance 130 2.2.2.2 0.0.0.0 1 Ip as-path access-list 1 permit _600$ route-map setCommu permit 10 Origin IGP, metric 0,ccnp route exam practice, localpref 100, valid, external, multipath Path Use ip community-list to match the community value 10 Enhanced Interior Gateway Routing Protocol (EIGRP) Open Shortest Path First (OSPF) If there is an EBGP connection between R2 , then a routing loop occurs, and R1 and R2 will receive the summary route and accept the routing update. This is because this summary route does not carry any information about AS100 and AS200 . The MAC sublayer is responsible for the following tasks: Non-default (manually configured non-default) priority and cost unchanged Pay attention to the changes in our experimental environment. The community value carried in 12.12.12.0 is no-export , if we only want to match no-export The message contains: 16/32 bit In the ETHERNET_II frame, the upper layer protocol is distinguished by the Type field. At this time, it is not necessary to implement the LLC sublayer, and only one MAC sublayer is included . And IEEE802.3 frames in the LLC sublayer of the link layer in addition to the traditional definition of services, but also adds a number of other useful features. These features are provided by the DSAP , SSAP, and Control fields.