ccna dump file

ccna dump file

Image Policy-based Routing ( PBR ) Policy Routing Precautions Port number 520 This is the general case, of course, there are two situations, it depends on the specific environment and the specific routing protocol. Show vrf ipv6 view vrf ipv6 Cc01.0cf0.0000 UDP The cost of the route. Gateway of last resort is not set 9.0.0.0/24 is subnetted, 2 subnets Turn on router advertisement at the same time (default is off) Interface fastEthernet 0/0 ipv6 ospf 1 area 0 !! Configure the DHCP client and specify the prefix name obtained as test (local valid) First on PE1 , take a look: 32 bits Image Image Image Ipv route 2222::/64 fastEthernet 0/0 FE80::CE00:1AFF:FEE4:0 Origin IGP, metric 0, localpref 100, valid, internal, best Extended Community: RT: 234: 4 Interface FastEthernet1/0 Tunnel Tunnel interface Ospf rip static ! Redistribute connected metric 10 subnets route-map test network 192.168.23.3 0.0.0.0 area 0 RIP based on rumor updates Ipv6 router rip RIPprocess exit ip route 172.16.1.0 255.255.255.0 192.168.12.1 !! go subnet route 4 Y Route redistribution is directed. The routing information of the A routing domain is injected into the B routing domain. We need to configure it in the process of the B routing protocol. For example, to redistribute other routing protocols to RIP , then configure. As follows (republishing to other routing protocols is similar): Routing Feedback (feedback) is a re-release in the deployment of routing requires a great attention to the phenomenon. As shown above, R5 will EIGRP , BGP and other dynamic routes learned. Ip cef ! Use 224.0.0.9 134 Ipv6 unicast-routing The router queries through recursion, the next hop 2002: CA65:1703::FFFF should be thrown to tunnel0 ,ccna dump file, and tunnel0 is a 6to4 tunnel, so the 2002:CA65:1703::FFFF is translated into the corresponding V4 address, which is 202.101.23.3 --- Image Policy deployment in BGP 0x0000000E RIPng Exit-address-family The first 8 bits of the route must match the first 8 bits of 172.0.0.0 , the other bits do not care, and the mask must be /8 , /9 , /10 , ..., /24 Image Ipv6 route 2002:CA65:1703::/48 Tunnel0 Re-advertise routes between different OSPF processes Precautions Routing, then: Network 10.1.23.3 0.0.0.0 area 0 So in fact, it is very simple, as long as the prefix and mask part of the route, respectively, use the source and destination parts of the ACL to match. Ip address 10.1.23.2 255.255.255.0 Address resolution OSPFv3 the RouterID or 32bits , if not on the router IPv4 address, in OSPFv3 manually specify the required process After " 10.1.20.0 " is passed to R2 , since the updated subnet is consistent with the R2 interface main network, R2 receives the update, and uses the interface mask /23 as the mask of the received RIP subnet, then R2 local loading This RIP route is 10.1.20.0/23 . In fact, the prefix length of the route is wrong. We can configure a secondary address on the R2 interface. In this way, RIP will use the mask of the secondary address (if configured) to receive the route. For example, configure R2 with 10.1.123.222/24 .