ccnp tshoot chapter 2 answers

ccnp tshoot chapter 2 answers

MED , choose 3 switchport trunk encapsulation dot1q switchport mode trunk Router(config-dhcp)#default-router [host address] The route for no-export cannot be more or less. Route-map defaults to permit , the default serial number is 10 , the serial number is not automatically incremented, and the serial number needs to be specified. ? *> 100.0.1.0/24 Access-list 1 permit 1.1.1.0 Match interface matches the route with the next outgoing interface as one of the specified interfaces. If the local BGP advertiser becomes the next hop address, the next hop field in the local BGP RIB is 0.0.0.0. 10.1.12.0 [110/128] via 10.1.23.2, 00:06:40, Serial0/0 0100.e01e.6012.89 On the other hand, we capture the package: ... Redis ospf 1 route-map test Aggregate-address 172.16.0.0 255.255.0.0 as-set summary-only switchport trunk encapsulation dot1q switchport mode trunk Open Shortest Path First (OSPF) Routing Information Protocol (RIP) Route map reference The number of messages received by MsgRcvd from neighbors Hash The router uses this information to construct a new Layer 2 header for the data frame and then forwards the message to the outbound interface pointing to the next hop. Configuration example: Neighbor 10.1.12.2 remote-as 200 Ip address 10.1.45.4 255.255.255.0 R3-R4 ; R4-R5 ; R3-R5 maintains IBGP neighbor relationships and uses their respective LOOPBACK ports as update sources and establishes Load balancing Accept either real AS or local AS from the ebgp peer . Translation: EBGP peers can use either PriAS or SecAS to local remote-as . For example, after configuring the above command on R2 , R3 is 10.1.23.3 . In its BGP process, you can use neighbor 10.1. 23.2 remote-as 200 ,ccnp tshoot chapter 2 answers, you can also use remote-as 201 to refer to BGP neighbor R2. The vocation of the router is to maintain the routing table and use the routing table for data forwarding. The routing table contains routing entries or routing entries learned through various channels. The simplest and most straightforward method is to use static manual configuration to create routing entries for the router. This method is the most direct and controllable. The highest, the most simple configuration. In a small network, there seems to be no problem with static routing on the whole network. However, in a large network, if you use static routes purely, the workload is very large, not only the workload is large, but another more important defect is Static routes cannot be adjusted according to changes in network topology. Therefore, in large-scale networks, we often use static + dynamic routing protocols to complete route deployment.