ccna final exam answers

ccna final exam answers

After completing this configuration, take a look at the phenomenon: Type 1 length 52: Set-overload-bit suppress interlevel external Version/ Protocol ID extension: Value is 1 SystemID (DIS) : LAN ID . It consists of the SysID of DIS and a 1- byte pseudonode ID . The LAN ID is used to distinguish the same one. Reservable Bandwidth[7]: *Aug 18 09:06:02.699: min unit=0 bytes, max pkt size=2147483647 bytes Activate the MPLS TE tunnel feature on the interface. Basic command Tib entry: 1.1.1.1/32,ccna final exam answers, rev 2 Removal Trigger: re-route path verification failed The VRF IGP running between PE and CE is OSPF , using process number 1. 10.1.34.0/24 Se1/0 55000 Experimental results: Three-Way Handshake for IS-IS Point-to-Point Adjacencies Ip address 3.3.3.3 255.255.255.255 75000 *Aug 18 11:26:02.546: The configuration of R4 is as follows: *Mar 1 00:00:32.759: ISIS-Upd: full SPF required Address-family ipv4 vrf VPN-A no synchronization !! Note area0 and area1 must activate MPLS TE Ip cef ! R1#show mpls traffic-eng tunnels Point2 Mpls traffic-eng tunnels ip rsvp bandwidth 129 Of course, both IS-IS and OSPF have been successfully tested during the test and have been eligible for the ISP network intranet IP routing protocol. Both protocols have achieved some new extensions over the past few years. For example , support for MPLS TE , support for IPv6 , and so on. On the other hand, one of the more intuitive phenomena we can observe is that OSPF has much more technical documentation than IS-IS .