ccnp tshoot skills based assessment answers

ccnp tshoot skills based assessment answers

Sh ip bgp neighbors {address} advertised-routes ARP ACL and relative priority of DHCP snooping database entries Mapping is only valid locally Note the tool. Here is actually a summary of the deployment of static routes, of course, in addition to we can also route summary in the dynamic routing protocol, almost all dynamic routing protocols support route summarization. BGP table on R4 : If R1 turns on auto-summary and network 1.1.1.0 , the announcement is unsuccessful. Router(config)#ip dhcp excluded-address 172.16.1.100 172.16.1.103 MsgSent If R2 on ip route 1.1.1.0 255.255.255.0 null0 , this time there is no routing table OSPF of 1.1.1.0 routing the unsuccessful thus re-release, so R3 can not learn the 1.1.1.0/24 route; OpenConfirm Determine if the frame has a VLAN tag . It can still be saved after the up/down phenomenon occurs. After using wr , these sticky secure addresses will be written to start-up config and will not be lost even if the device is rebooted. On R2 : Interface fast0/0 Not advertised to any peer Local Path 3.3.3.3 FastEthernet0/0 Similarly, if ip route 3.3.3.0 255.255.255.0 null0 is the same. Vlan 10 When both the primary and secondary addresses exist, RIP will use both the primary and secondary addresses as the source to send routing updates. So R1 and R3 will learn the routing update of 2.2.2.0 . But R3 ca n't learn 1.1.1.0 , on the one hand, because R1 sends updates to R3 and is ignored by R3. A static route to the host Milne is added to the ROO . The next hop is the E1 port of Kanga . The purpose is to pass the bridge that is often congested. But found that Kanga will be sent to the host The secure address entry can be configured by using the MAC ( SecureDynamic ) dynamically learned by the port , or by manually configuring the interface ( SecureConfigured ) and the sticy MAC address ( SecureSticky ). I can't ping because I found a subnet route after looking up the table at 172.16.1.1 . Therefore, the search is limited to the subnet route, and then the route is found to be mismatched. Therefore, the packet is discarded directly without going through the default route. . Network Sign / / Configure etherchannel , ID is 1 ,ccnp tshoot skills based assessment answers, the mode is desirable Test purpose: trunk allowed vlan ? 300 Fast switching means that all packets destined for the specified destination are sent out from the same interface , so the exchange time and processor usage are greatly reduced. When packets destined for different hosts in the same network enter the router and there is also an optional route , the router will send the packet to the destination on the other path. So the router can do its best based on the balanced load of the target network.