Free Cisco Written Dumps
For Top 50 Purchases 01:59:56

X

lab ccna

Demo1:

ProblemServer 1 can not get ip address.

Materials:

SW3#show ip dhcp snooping  

Switch DHCP snooping is enabled

DHCP snooping is configured on following VLANs:

none

DHCP snooping is operational on following VLANs:

none

Smartlog is configured on following VLANs:

none

Smartlog is operational on following VLANs:

none

DHCP snooping is configured on the following L3 Interfaces:

Insertion of option 82 is enabled

   circuit-id default format: vlan-mod-port

   remote-id: 0018.b9da.5300 (MAC)

Option 82 on untrusted port is not allowed

Verification of hwaddr field is enabled

Verification of giaddr field is enabled

DHCP snooping trust/rate is configured on the following Interfaces:

 

 

Interface          Trusted     Allow option     Rate limit (pps)

 --------------------   -------         ------------     ----------------  

Q1Which material is most helpful

Q2:which packets can help you find the cause


Demo2:

Customer just setup a IPv6 Network, with HSRPv6 on R1 & R2. After setting up, all hosts lose connection.

What would you recommend to your L1 Engineer as a Quick Fix?

CE1 key configuration

standby 1 priority 200

standby 1 preempt

ipv6 nd router-preference low

CE2 key configuration

standby 1 preempt

ipv6 nd router-preference high 

 

 

I think it is a rouge device because I don't see any problems with the HSRPv6 config. PCs are configured with "ipv6 enable", "ipv6 autoconfig"

The R1 have a "ipv6 nd-preference high" and R2 have "low" if I'm not wrong.

 

How fast fix the problem?

 

¡ Shutdown the link between CE2 and PE2.

¡ Shutdown the link between CE1 and PE1.

¡ Configure CE1 with highest HSRPv6 Priority.

¡ Configure CE2 with highest HSRPv6 pirority.

¡ Configure CE2 with low HSRPv6 priority.

¡ Shutdown CE1 interface e0/0.

¡ Shutdown PE2 interface e0/0.

¡ Disable fast-switching on CE's LAN.

¡ Enable fast-switching on CE's LAN.

¡ Change HSRPv1 to HSRPv2 version


lab ccna


Here is the most accurate CISCO CCIE WRITTEN exam questions and answers. All study materials need to be carefully selected by professional certification experts to ensure that you spend the least amount of money, time, and pass the high quality exam. There is also a professional service team that can customize your study plan for you to answer all your questions, PASSHOT's CCIE Written Dumps is definitely the biggest boost for you to test CCIE that helping you pass any Cisco exam at one time.

CCIE Routing and Switching LAB Dumps

( 6 People are currently looking at this product )

Exam Code: CFG: LAB1、LAB1+、LAB2、LAB2+、LAB3
TS: TS1(5 sets)、TS2(3 sets)
DIAG:DIAG 1~DIAG 8(8 sets)

Certification Provider: Cisco

Certification Exam Name:CCIE Routing and Switching Lab

Update Date: Dec 21,2024

Free Cisco Written Dumps
For Top 50 Purchases
Latest Dumps
Numbers of Question & Answers

    lab ccna

  • 3245 Reviews
  • Private There IP public network router will not appear in the routing table .   Change the interface mode to trunk working mode   Ipv6 ospf cost 20 1 1 Rommon8>Sync (Save Parameter Configuration) In the future, I can finally learn what I want to learn, but I also have my own wish. I also gave myself a two-year network to pass the exam. I will live a good life, work hard, and work hard. nvRam : Startup-config startup configuration file , or user profile       Navigating Basic Cisco ASDM Features perseverance of learning. Teachers Encapsulation frame-relay   7. Application layer : user interface   =========================================================== ===============   1. The other party did not have a no shutdown activation port   Q2: R14, next-version op-self Assigned for this sub-specific interfaces of PVC. ??? is a PVC number .   (4) CCIE has great brand value =========================================================== ===============      In the interface turned off CDP protocol ( only affects the specified interface )   HDLC:   Ip routing vol 1, LAN SWITCHING, Internet Architeche. LAN at the time 2. Storage forwarding : slow speed , to ensure the correctness of the frame being forwarded .   When the candidates who followed the exchange of TS1's MPLS *** solution, the language was too rigid. From PC104 to SW3 to R9~ all the way up to check the default route, RT,lab ccna, neighbors, R7 routing and NAT, almost no idea. There are several other institutions in the 4 points that are directly linked to the candidates. 1. In hop count of the amount of 2 supports a maximum support . 6 paths share the load (default set to 4)   PS: There are a lot of pictures in the version, and the requirements are detailed. So the test preparation partners don't worry about not drawing! ! Actually, it is basically not used after you are familiar with it.    Avoidance     TCP is a connection-oriented protocol. Connection-oriented protocols provide more sophisticated flow control and error control than connectionless protocols. TCP can ensure the quality of data transmission, which is more reliable than UDP, but it is slower than UDP because of the need for additional error detection and flow control. the network world, and also participated in several product conferences +   2. Switch to bridge the number of segments ( ports ) have the number of collision domains .   Copy running-config tftp:   Debug ppp authentication      Assume that the file being copied by the user contains simple ASCII text. If it is not UNIX running on a remote machine, ftp usually automatically adjusts the contents of the file when the file is transferred in order to interpret the file as another computer to store the text file. format. To be frank, there is another factor driving me to take multiple CCIE qualifications. Everyone who knows me is likely to say that I am a strong competitor. Looking back at the company's hiring boom, we proposed to raise the recruitment requirements very high, and those who came to the interview were carefully selected because the people who were hired would immediately join our group. Because of this rigor, we have found a suitable candidate to form a dream combination of network engineering. In my direct team, there are 10 SiS engineers, two of whom have already obtained the qualifications of two CCIEs. Two of them have obtained three CCIE qualifications, and I am one of them. I wouldn't be surprised if the data I provided above was outdated when the visit was published (for example, one of them has obtained one more CCIE qualification). Therefore, it goes without saying that in such a friendly and competitive environment, we are pushing each other forward.

Have any question for us?

Cisco Dumps Popular Search:

ccnp 300-135 drag and drop ccie sp v4 real lab ccie mpls lab ccnp 300-115 official cert guide pdf ccnp route 300-101 dumps ccnp switch exam 2018 ccnp route 300-101 frame relay free ccna questions ccnp route manual ccna r&s syllabus pdf

Copyright © 2024 PASSHOT All rights reserved.