ccna r&s syllabus pdf

ccna r&s syllabus pdf

Circuit type : 01 means L1 router, 10 means L2 router, 11 means L1/2 router 0 kbits/sec Nolabel/506 R1 is based on the remaining two paths, then compare TE metric (default is equal to IGP Metric ) R1 is isis neighbor directly is empty, because it ignores received on this interface R2 of hello packets. Reservable Bandwidth[7]: Physical_bw: 100000 (kbps), max_reservable_bw_global: 75000 (kbps) Interface eth0/0 3.3.3.3/32 L1 / L2router with the set attached-bit route-map associated with a route-map test deny the route-Map , it. Ip address 3.3.3.3 255.255.255.255 0x0000000D Using domain authentication, IIH packet, CSNP , PSNP is not carrying authentication information, LSP is used to carry the authentication TLV . Use the detail keyword to view the details of the LFIB forwarding entry, including the Layer 2 information, and all the label content. If you don't add it, you can only see the top label. TTL-propagate IS-IS uses a simple two-layer structure. The IDP and HODSP are combined to be used as the area ID of the Layer 2 route , and the remaining system IDs are used as the first layer of routing. Detailed information The configuration of R2 is as follows: R2(config-if)#mpls traffic-eng administrative-weight 100 Age Config Parameters: Each LSP has a maximum expiration time ( MaxAge ) in the LSDB . If this time expires, if no new LSP is received. Tib entry: 1.1.1.1/32, rev 2 0/0/0 Tspec: ave rate=0 kbits, burst=1000 bytes, peak rate=0 kbits RSVP Resv Info: Not supported yet Bandwidth , latency , policy constrains 2.2.2.2 Inter-area IP routing changes; By default, Cisco IOS starts both L1 and L2 operations on the IS-IS router . If you want to specify the router as only the area router or trunk router , use the router configuration mode: IP interface address Mpls traffic-eng tunnels mpls label range 500 599 16 MPLS TE improves the efficiency of traffic spread across the network, avoiding inadequate and overuse of links. LSP Seq Num LSP Checksum LSP Holdtime Mainly contains TE tunnel bandwidth request LSP Tunnel R1_t0 is signalled, connection is up Affinity Bit : 0x0 IGP Metric : 1 SESSION R3.00-00 Pop tag There have been a lot of talks about ATT-bit before, so I won't be embarrassed here. I have tested on CISCO IOS Version 12.4(10) -- C3640-JK9O3S-M . On R1,ccna r&s syllabus pdf, which is L1 router , with default-information originate , I can't generate default route. After the tunnel setup failed Router isis Can be modified as the basis for calculating the shortest path of the TE tunnel So we have also defined an explicit null tag to handle the scenario described above. The configuration of R2 is supplemented as follows: !! Path error message sent by R2 to R1 The configuration of R3 is as follows: For the setting of SystemID , it is customary to encode the interface MAC or IP address of the router into a system ID or a part of it. Loopback IP is commonly used for this purpose in integrated IS-IS . For example, I have configured a loopback : 192.168.1.24/32 , and then I will complete this IP , not enough 3 digits to add 0 in front , forming 192.168. 001.