ccna mock test online

ccna mock test online

200-299 ; P has a label space of 300-399 ; PE2 has a 400-499 . DAD ( Duplicate Address Detection ) Since Source Address Ipv6 rip 1 default-information only //In interface mode, only the default route is advertised, and other routing information is prohibited. Adding the default keyword will cause the interface to install a default route after getting the address through stateless autoconfiguration. 20 2 : RIP-2 . Which exchange method will be used Well, then continue, now R1 and R3 Ethernet interfaces are activated RIPng , so both interfaces will multicast RIPng messages to the LAN , and this action is actually meaningless, so we can use this Ethernet The mouth is passive . Unfortunately, there is no mechanism for defining passive-interface in RIPng . (Update source verification failed), on the other hand, R2 will not receive the 1.1.1.0 route from R1 , and then pass the same interface,ccna mock test online, with 11.1.123.2 PC can take the initiative to send RS to trigger router sends RA , without waiting for RA periodically sent before closing time to the RA . FF00::/8 twenty two Image Image CISCO IPv6 Network Implementation Technology: CISCO self-study : Implementing Cisco IPv6 Networks (IPv6)IPv4 Application Interface fast1/0 2 : Clear text verification; Ipv6 address 2001:0001::FFFF/64 * 0x0000000B Vif PGM Multicast Host interface The cost of the route. OI 2001:1:1::1/128 [110/192] Test description: ping FF04::1 on R2 , Fa0/0 on the outbound interface 0.0.0.0 . OSPF V2 has similarities with V3 : The interface address is 2001::1/64 . Note that if you use a virtual machine configuration, you must manually configure the linklocal address on the serial interface. Ip sla monitor schedule 2 life forever start-time now FF02::1:FFF0:10 The IPv4 and IPv6 address plans are as shown in the figure above. R1(config-router)#distribute-list 1 out ? The A record in IPv4 is used to map the host name to a V4 address, and the AAAA resource record maps the host name to an IPv6 address. We can do a test: Remarks Image BGP table version is 2, local router ID is 2.2.2.2 Command Interface Reserved unspecified, loopback, IPv4 compatible address Image Async Async interface Neighbor status tracking Image Neighbor FE80::CE01:8FF:FED8:10 remote-as 12 Prefix list configuration Prefixing ::1 Neighbor 4.4.4.4 update-source Loopback0 Although route summarization is indeed a very very important idea and tool, it is cautious to use. After all, it reduces the routing entries and reduces the granularity and accuracy of the route. Looking at the figure above, a static summary route is configured on the egress router, and the next hop is a Layer 3 switch. The Layer 3 switch configures a default route to send the traffic to the egress router to the egress router. The next hop is the egress router. This network will not have problems when the traffic is normal, but now the intranet users are poisoned, so these PCs start to send crazy.