cisco sample exam

cisco sample exam

See below for more details. Needless to say this? Activate CEF 0 kbits/sec 0 kbits/sec *Aug 18 11:26:02.546: Net 49.0001.0000.0000.0001.00 ! SESSION Prefix Metric: 0 C 1.1.1.0 is directly connected, Loopback0 2.0.0.0/24 is subnetted, 1 subnets The loopback0 address of all devices is xxxx/32 , and x is the device number. Tunnel mpls traffic-eng path-option 10 explicit name R2R4R5 no routing dynamic Mpls traffic-eng tunnels mpls label range 400 499 LSPID LSP Seq Num LSP Checksum LSP Holdtime ATT/P/OL The composition of the router , Backbone must be continuous. All routers run IS-IS R2 redistributed direct route 2.2.2.0 is gone, inter-area route is still,cisco sample exam, and R1 no longer uses R2 as the next hop of the default route. Note that the LSP sent by R2 is also overload-bit set. . 0 packets, 0 bytes 0x00000037 Mpls traffic-eng router-id loopback0 mpls traffic-eng area 0 Tspec parameter id = 127, flags = 0, length = 5 Although the L1 / L2 router having both L1 and L2 function, but sometimes simply Establishing a specific interface on a layer adjacent relationship, are arranged on the other interfaces in the first 2 layers adjacent relationship. R2 is preferably a route from the tunnel port. At this time , the traffic from R2 to 55.55.55.55 is on the tunnel , and the LSP is used for label switching. Bandwidth: 0 Verify and view Configure on R2 as follows: Verify view Ip rsvp bandwidth LSP We see that on R2 , about 5.5.5.5 and 55.55.55.55, the R5 is the "rear" network at the end of the tunnel . The outgoing interface is tunnel0 . This means that when R2 receives data destined for these two network segments, it is placed directly into the TE tunnel . Compared to the way static routes are placed, the advantages of autoroute are shown. My Address: 10.1.12.1 R1#show isis neighbors After the MPLS LDP-IGP synchronization is activated on an interface , the IGP will advertise the metric of the link to the maximum until the synchronization is complete or the LDP session is successfully established on the interface. In OSPF , the metric is up to 65535 . In this way, it can be guaranteed that no path will pass through the interface when LDP is in the disconnected state.