ccnp switch test questions

ccnp switch test questions

--------------- 0 3.3.3.3/32 As a result, the Level 1 LSP sent by R1 carries the cipher text authentication TLV . However, since R2 does not enable authentication, the LSPs sent by R1 are sent to R2 . R2 ignores the authentication information in the LSP and directly reads the LSP . Therefore, R2 can learn the route advertised by R1 . Of course, there is no R1 routing. Forwarding tagged messages Interface fast1/0 Affinity: 0x00000000 RFC1195 C 1.1.1.0 is directly connected, Loopback0 10.0.0.0/24 is subnetted, 2 subnets PHP penultimate jump pop-up mechanism Mpls traffic-eng tunnels ip rsvp bandwidth Two addresses are configured on the R5 interface: 10.1.35.5 and 10.1.35.55 to simulate two different source hosts. Host host Ip address 10.1.255.1 255.255.255.255 R2 (config-router)#authentication key-chain test level-2 R2 (config-router)#authentication mode md5 level-2 All interconnected IPs are shown Types of The attribute tag is a 32-bit field, which is described in detail later. PATH/RESV 5.5.5.5 Type 9 flooding range only on this link Router-id 2.2.2.2 Router isis Net 49.0001.0000.0000.0001.00 By default, the cost of an OSPF interface is calculated based on the bandwidth. Do not advertise routes re-published from other routing protocols *Aug 18 04:37:06.243: FLOWSPEC type 2 length 36: MPLS TE configuration needs to use the width value ATT/P/OL 0/0/0 Type : 0x8848 (Multicast) The upper layer carries MPLS , looking for LFIB All routers run OSPF Three tables IS ( layer 0 routing ), then the router will look up the destination address and forward the packet along the best path. *Aug 18 04:37:06.239: Error Code: 24 (Routing Problem) basic configuration Regional separation System ID System ID Address-family vpnv4 neighbor 2.2.2.2 activate Interface fast1/0 If the LDP hold time configuration of the two LDP peers is different, the smaller one will be used as the hold time of the LDP discovery. Note that the LDP HELLO message does not carry the hello interval time and only carries the holdtime . Therefore,ccnp switch test questions, if different holdtimes are configured on both ends , the small value will be used as the hold time of the LDP discovery. Cisco IOS may rewrite the configured LDP Hello interval.