ccna international exam questions and answers

ccna international exam questions and answers

Bw[0]: 75000 Network 10.1.23.2 0.0.0.0 area 0 TOS 0 Metrics: 1 Oper: up Tib entry: 10.1.12.0/24, rev 4 LSP Seq Num 2 Mpls ip Device Configuration Test 1 : set-overload-bit In the routing table, R3 goes to 1.1.1.1 and uses 10.1.34.4 and 10.1.23.2 equivalent load balancing. The configuration of R4 is as follows: The configuration of R4 is as follows: Fa0/0 For example, in the above topology, R1 establish a to R4 of TE the Tunnel , all routers have declared their loopback into OSPF . All interfaces cost are 1 . Network 10.1.34.3 0.0.0.0 area 0 During the establishment of the adjacency relationship, the neighbors send CSNPs to each other (the CSNP is not sent after the adjacency is established ). the term Interface Serial1/0 Fast tag rewrite with Fa0/0, 10.1.12.2, tags commit: {203} via 10.1.12.2,ccna international exam questions and answers, FastEthernet0/0, 0 dependencies Tspec: ave rate=2000 kbits, burst=1000 bytes, peak rate=2000 kbits RSVP Resv Info: Mpls traffic-eng tunnels mpls label range 200 299 ! Ip unnumbered Loopback0 tunnel mode mpls traffic-eng tunnel destination 5.5.5.5 0 kbits/sec First we need a routing protocol that can advertise various network resources (weights, IGP metrics , available bandwidth, link attributes, etc.). This routing protocol must be a link-state routing protocol and must support MPLS TE extensions. We have two Optional, one is OSPF and the other is IS-IS . In the CISCO IOS based "internal for MPLS TE link-state routing protocol extensions " to the TE information to build a TE database , the database contains all enabled MPLS TE characteristics or parameters of the links and the links. Parameters such as bandwidth and link attributes that can be used for MPLS TE are configurable on all links in the network.