ccna exam dumps

ccna exam dumps

IPv6 routing basis Ipv6 ospf 100 area 1 interface loopback0 Packets OI 2002::1/128 [110/64] ! Router(config)#ipv6 unicast-routing Router(config)#intertface f0/1 Experiment 3 Of course, you can also associate the route-map after re-issuing the command and set the tag in the route-map . Redirect message Extended header Ipv6 router ospf 1 router-id 1.1.1.1 Now, change the interface ipv6 MTU of the F1/0 port of R2 to 1400 bytes (the default interface IPv6 MTU in the above figure is 1500 bytes): ! Interface fast0/0 Ipv6 enable R4#sh isis da R4.00-00 l1 detail Image Prefix announcement Ipv6 route 2002::/16 Tunnel0 [Experiment 7 ] There are subnet routes (no match); there are default routes Image No shutdown interface loopback 0 Connect to a specific DNS suffix . . . . . . . : When the host communicates with other IPv6 hosts, it forwards from the tunnel interface and takes the IPv4 address from the next hop IPv6 address of the packet as the destination address of the IPv4 encapsulation. If the destination host is in the site, the next hop is the destination host itself. If the destination host is not in the site, the next hop is the address of the ISATAP router. After the above configuration, A can initiate access to B , and uses the destination address 2001: 2 :: 2 to access B The configuration of R2 is as follows: ! Is the checksum of ICMPv6 correct? NAT-PT 2 : Reponse message, send all or part of its routing information, in a Response message AH head, this is very familiar Router bgp 300 Tunnel source Serial0/0 tunnel mode ipv6ip 6to4 Image Preferred lifetime ( of Preferred Lifetime ) In the example, the static route associated with the next hop does not have this attribute, so it is not matched. Interface Serial0/0 So match interface is a match with the outbound interface attribute, and this Via 10.1.13.3, FastEthernet1/0, 0 dependencies R2(config)#router ospf 1 Interface Tunnel1 ! 10.1.12.2 Level2 router factor The configuration of R2 is as follows: Neighbor FE80::CE01:8FF:FED8:10 activate redistribute connected route-map test R4#sh ip ro 192.168.1.0 Client configuration The configuration of R3 is as follows: *>i2001:5555::5/128 Redistribute connected metric 10 subnets route-map test network 192.168.23.3 0.0.0.0 area 0 RIP Version 2 MIB Extension ! * 0x0000000B R2#sh ip bgp ipv6 unicast !! off-link is related to the L bit,ccna exam dumps, which is defined in RFC2461 . When the optional off-link keyword is configured in CISCO IOS , the L bit is turned off. And if the L bit is turned on (by default), he indicates that the prefix in the RA message is assigned to the local link. Therefore, the node that sends data to the address containing this specified prefix considers the destination to be reachable by the local link.