ccnp switch badge

ccnp switch badge

100 RIPv1 , v2 Traffic share 1 Origin codes: i - IGP, e - EGP, ? - incomplete Part of static configuration, part of dynamic learning ORIGINATOR_ID is a 32-bit value created by a route reflector . This value is the IBGP routerID of the route initiator in the local AS . Note that this initiator is not necessarily the initiator of this route (there is experimental verification below), if the initiator finds its RID In the received route Configuration Revision 15 Tag 1111, type extern 2, forward metric 64 BPDU format and operation Forwarder 1 State is Active ! Ip summary-address rip xxxx yyyy // Note that this summary does not support CIDR supernet . IBGP non-equivalent load balancing By AS_PATH influence route selection Next hop 10.1.13.3, FastEthernet1/0 valid adjacency Hard reset When the topology changes, the spanning tree protocol can detect these changes and automatically adjust the interface status in time to adapt to network topology changes and achieve link redundancy. You can use ^ at the beginning of a range to exclude all characters in the range, or you can use an underscore _ to specify an interval. The physical interfaces belonging to a port-channel must have the same configuration as below. 170 Neighbor 10.1.12.1 remote-as 13 Very thorough analysis of the foregoing, when the RIP to OSPF do two-dot weight when released, since the routing is injected into OSPF later, the AD becomes 110 , then transmitted to the route R2 ,ccnp switch badge, R3 Thereafter, since OSPF the AD than RIP smaller Therefore, the OSPF route will overwrite the RIP , resulting in a sub-optimal path. Then, we can use ACL and other tools to capture the routes in the RIP domain on R2 and R3 , and then adjust the AD values ​​of these routes to be larger than RIP in the OSPF process . Then, these routes are RIP routes will not be overwritten, and suboptimal path problems can be circumvented.