ccna free dumps download pass4sure

ccna free dumps download pass4sure

Image Router(config)#ipv6 unicast-routing Router(config)#intertface f0/1 Ipv6 nat v6v4 source 2001:1::1 202.101.100.111 Ip route 0.0.0.0 0.0.0.0 10.1.12.2 Configuration prefix re-programming Here we use a access-list 1 match 202.101.100.0/24 network, while it with v4v6-pool this IPv6 address pool to do a bundle Ip address 192.168.10.254 255.255.255.0 None Router(config-router)# no adjacency-check X Floating static route Ipv6 unicast-routing interface Serial0/0 encapsulation frame-relay When the router performs a classless route lookup (by default, ip classless ), it does not pay attention to the class of the destination address. It performs the longest match between the destination address and all known routes bit by bit . Ipv6 rip 1 default-information originate // Release the default route into the RIP process in interface mode (local static route is not required) Ipv6 address 2001:12::2/64 At infinite RIP-1 compatibility RIPv2 sends updates in the form of broadcasts, enabling V1 to receive ! Ip cef 134 Internal 0 packets, 0 bytes ! Adjust the management distance of the routing protocol Router(config)#ipv6 unicast-routing Router(config)#intertface f0/1 Neighbor FE80::CE02:8FF:FED8:0 activate Neighbor state Stateless address autoconfiguration Experiment 2 Tunnel source Serial0/0 tunnel mode ipv6ip 6to4 0x7768 When ISP1 is down, and the GW does not detect it (that is , the interface of GW connected to ISP1 is not DOWN ), the traffic of PC access 100 is still thrown to ISP1 , which is disconnected. Ip address 10.1.23.2 255.255.255.0 Interface FastEthernet1/0 Address-family ipv6 RIP V1 supports a maximum of 6 and defaults to 4 equivalent load balancing. And does not support verification. V2 supports verification. In addition, IS-IS neighboring routers have a very important factor to consider. In an IPv4 or IPv6 single-protocol environment,ccna free dumps download pass4sure, IS-IS adjacencies and information interactions are not problematic. However , care should be taken when enabling both protocols ( IPv4 and IPv6 ) on all neighboring IS-IS routers . In this particular case, the two protocols must be enabled on all IS-IS neighboring routers. Otherwise, the IS-IS router will no longer maintain the adjacency relationship with all its IS-IS IPv4 neighbors. In fact, when Level1 or Level1-2 IS-IS router in adjacency checking is enabled, it checks from the IS-IS the neighbor Hello message, if the neighbor to use a different set of protocols, it refused abutting relationship therewith.