ccna 200-125 dumps google drive

ccna 200-125 dumps google drive

We look at the above picture, the external detail route 172.16.32.0 – 39.0/24 , and the summary route 32.0/21 are introduced into OSPF by R1 , now BGP state = Established, up for 01:05:47 16 Access-list 1 deny 192.168.13.0 access-list 1 permit any Image Y Image 0200 – 03FF Windows host articles Image Ip address 10.1.34.4 255.255.255.0 Image O - OSPF intra, OI - OSPF inter, OE1 - OSPF ext 1, OE2 - OSPF ext 2 ON1 - OSPF NSSA ext 1, ON2 - OSPF NSSA ext 2 A tool used to control routing updates can only filter routing information and cannot filter LSAs . Routing Information Protocol (RIP) Interface tunnel 0 Ipv6 enable Avoid routing loops with triggered updates Via FE80::5C10:8CFF:FEE0:FE89, Serial0/0 Path control The first 8 bits of the route must match the first 8 bits of 172.0.0.0 , the other bits are not concerned, and the mask must be /8 . ND reachable time is 30000 milliseconds BGP table version is 1, main routing table version 1 Image Link-layer Addr Image After receiving the packet check, R2 finds that this is the IP of the same subnet as the interface that accepts the update package , so accept this update. Therefore, this test, although the interface masks on both sides are different, but can accept each other's updates, and can also ping between 1.1.1.1 and 2.2.2.2 . Interface fast1/0 Ipv6 mtu 1400 The next hop address is 128bits 6000 – 7FFF Neighbor 4.4.4.4 send-community extended exit-address-family Interface fast0/0 ipv6 enable We finally do another test, that is, the ISATAP host pings 2008: 8888::1 . 1/8 Certification 20 Ipv6 nat v6v4 source 2001:1::1 202.101.100.111 Set metric-type sets the metric type of the target routing protocol Experimental needs Link-local address (Link-local address) If the packets of the same data stream are sent in different paths, the IP packets may need to be re-queued when they reach the destination. This may reduce the forwarding performance of traffic such as VoIP , or if the packets arrive out of order, the quality of service will be degraded, packets may be discarded, and delay jitter will be added. 10.1.12.2 Ipv6 unicast-routing interface fast0/0 Image Address classification Image Access-list 2 permit 10.1.2.0 route-map cisco permit 10 R 3.0.0.0/8 is possibly down , routing via 9.9.12.2, FastEthernet0/0 201 The first 8 bits of the route must be exactly matched with the first 8 bits of 172.0.0.0 . The other bits do not care, and the mask length must be greater than 24. Note that here Allocated aggregated global unicast address So now,ccna 200-125 dumps google drive, we add the following in the configuration of R2 : When one or more consecutive 16- bit fields are 0 , the ::: is available, but only one is allowed in the entire abbreviation: BGP table version is 5, local router ID is 2.2.2.2 RIP version number: Ipv6 enable After getting the 6to4 IPv6 address space, the address space is 16+32=48bits , which is /48 , so the space is very large, you can further divide the subnet. This IPv6 address space will be used for the intranet. . !! When the route matching ACL1 when ! Network 192.168.10.0 0.0.0.255 area 1 More than 30s has elapsed since the last reachability confirmation was received . Frame-relay map ipv6 FE80::5C10:8CFF:FEE0:FE89 102 broadcast ! Image The IP configuration is as above. The R2 interface is configured with two IP addresses, and both have announced that the entire network runs RIP . Now we are configuring ISATAP on the ISATAP host. Generally speaking, the IPv6 protocol stack is installed by default on the WIN7 system. By default , there will be an ISATAP virtual network card. After we configure the IPv4 address of the physical NIC of the PC , such as 1.1.1.1/24 , the ISATAP virtual NIC will automatically calculate the special interface identifier as described above based on this IPv4 address: 0200:5efe:1.1.1.1 , pay attention to this The format is equivalent to 0200:5efe:0101.0101 . On the windows system, we can see the simple way of writing the former.