ccnp r&s update

ccnp r&s update

Whenever a route is reflected by the reflector,ccnp r&s update, the cluster -ID of the reflector (the cluster) is added to the route's Cluster-list attribute. 10.1.25.2 ID . C 192.168.23.0/24 is directly connected, Serial0/1 The default native vlan is vlan 1 So R2 can ping through 3.3.3.3 [Experiment 6 ] There are subnet routes, the subnet route prefix length is different (matching and mismatching), and the matching route is taken. Message type AS_PATH , and AS_PATH only when routing out this AS or BGP routers to update EBGP will change when neighbors in AS inside will not change, therefore, in the AS internal, anti-ring requires the use of split horizon. So how to solve the problem that R5 ca n't learn routing? Route 3 : AS_PATH : 500 Match abd , abcd , abcdefg, etc. Weighting 100 (default 100), thresholds: lower 1, upper 100 Redistribute connected metric 10 subnets route-map test network 192.168.23.3 0.0.0.0 area 0 Access-list 1 deny 192.168.0.0 0.0.255.255 Implementation of CEF Obviously, the DHCP server is aware of the above problem, and the action it takes is to ignore this DHCP request. Therefore the PC cannot get the address. 10.1.25.2 100 i VLSM support 200 basic concept R2#sh ip bgp SW1 is an access layer switch. DHCP snooping is deployed and Fa0/24 is defined as a trust interface. Ip route 1.1.1.0 255.255.255.0 serial 0/0 IBGP established between neighbors neighbor, in order to ensure the stability of neighbor relations, general use loopback interfaces to establish, because if you use the physical interface, the physical interface failure, neighbor relations DOWN up, and AS inside, the path may be redundant LOOPBACK routes between neighbors can be obtained through IGP and provide some routing redundancy (when physical lines are also redundant). When establishing a BGP neighbor relationship using the loopback interface , be sure to specify the source IP address to be updated .