ccnp troubleshooting final exam answers

ccnp troubleshooting final exam answers

! *>i11.11.11.0/24 No synchronization no auto-summary Between R1 and R2 , the original R3 and R4 are updated through a multi-access network, and BGP is run . 100 i Set the interface to access mode We see that on R4 , there are redundant paths for the two networks of 100.0 , but they are not best . Naturally, R4 cannot use these routes. Why is it not best ? The reason is that the next hop, nexthop is unreachable. ? SwitchA hangs EtherType Fa0/20 Bytes ---------- AS_PATH several commands After the route-map is called, the matching action will be executed from the smallest sequence number. If the conditions in the sequence number are matched, the set command is executed . If the conditions do not match, the switch to the next sequence number is continued. Match the action. Based on UDP protocol ports 67 and 68 Solution 3 , so the above question is, R2 should not be to its EBGP announcement neighbor 1.1.1.0 , therefore CISCO support the use of command: Network Network 100 i In 802.1D , a non-root switch can generate BPDUs only after receiving the BPDUs sent by the root bridge from the root port . In RSTP , even if the non-root switch does not receive the BPDU from the root switch , it itself sends the BPDU with the " hello interval" period (default 2S ) . 10.1.12.2 Compatibility 37 Match tag 10 After the completion, the two PCs can communicate with each other. / / Used to match the BGP neighbors passed to my summary route , here is the IP of R4 We see that on R4 , there are redundant paths for the two networks of 100.0 , but they are not best . Naturally, R4 cannot use these routes. Why is it not best ? The reason is that the next hop, nexthop is unreachable. ? Last update from 10.1.12.1 00:07:30 ago Routing Descriptor Blocks: Last update from 192.168.101.10 on Serial0/0,ccnp troubleshooting final exam answers, 00:12:46 ago Routing Descriptor Blocks: Show ip route dhcp Displays routes added to the routing table by DHCP Network TCN BPDU (Note that in the actual environment, the situation may be quite different). Match comprising 100 and 200 of AS_PATH 100 i 2.2.2.2 mark Once the ORF is deployed , the BGP peers will negotiate the ORF capability in the open message when the BGP peer relationship is established . If the negotiation succeeds, the ORF content is pushed using the route-refresh packet . S0 192.168.12.1/24 r1 When the route-map is executed, the match statement contained in the policy-list called by it will be traversed and the match action will be executed . Synthesis example 2 : !! Do not write to option82 This way the routing table: Basic No default Note that at this time, in the routing table of R2 , the 3.0 route is killed. Note that, in fact this time, Area within OSPF routers generated LSA has been loaded into the R2 of the OSPF Database alone rather than in R2 from the OSPF Database calculated route and prepares route entry is loaded into the routing table before, in the distribution direction play a role in the list, the 3.0 routes filtered out, so R2 routing table, there is no 3.0 the OSPF routing. However, although there is no 3.0 route in R2's own routing table , this does not prevent R2 from flooding the relevant LSA to R3 . Therefore, R3 still has 1.0 , 2.0 ,3.0 and 12.0 of the OSPF routing.