ccnp tshoot 6.0 instructor lab manual

ccnp tshoot 6.0 instructor lab manual

? Note 21 Finally: R4#sh ip b RIP based on rumor updates Origin IGP, metric 0, localpref 100, valid, external, multipath , best Ip as-path access-list 1 permit .* router bgp 300 Inter- VLAN routing Focus on the configuration of GW : The following figure is the open message content of the negotiation capability parameter (note the ORF part) description Summary of 192.168.0.0/16 on R2 Not advertised to any peer Local Native vlan After an ARP ACL , if ARP packets are denyed by the ARP ACL , these packets are directly discarded, even in DHCP snooping. BGP federation Total MAC Addresses 0 Metric problems 44 If the route learns to an EBGP neighbor, it is reflected to all client and non- client IBGP neighbors. For the same BGP connection, the passwords must be the same; different neighbors can set different passwords. After the authentication is configured, all data segments transmitted through the TCP connection between the peers are verified. VTP Within the federation, both R3 and R4 belong to AS64512 . For R4 ( AS64512 ), R5 belongs to AS64513 , but for the federal outside, R3R4R4 is AS345 , and external extremities do not know that AS64512 and 64513 exist. There are 2 forwarders (1 active) ? / / Interface or protocol R2#show cef interface f0/0 FastEthernet0/0 is up (if_number 4) Modify the default value of the MED value R5 will receive BGP routes for the 10.0 network from R4 and R3 at the same time . R5 will first prefer R3 because the route that R4 passes to R5 keeps NEXT_HOP and is still R1 . Therefore , the next hop of this route from R4 on R5 . Unreachable, R5 is preferred to R4 by modifying the next hop to itself after R4 modification . Vlan 100 Application 66 Switches, we are in VLAN configuration on the interface IP address, VLAN interfaces we called SVI switched virtual interface, it is with VLAN a corresponding logical,ccnp tshoot 6.0 instructor lab manual, and virtual interfaces. A Layer 2 switch can only assign an IP address to a VLAN interface . Switch(config-if)# ip address 192.168.255.1 255.255.255.0 In R3 and R5 between increasing an IBGP connection, thus R3 and R5 of BGP routes do not need to pass by R4 (albeit over a packet still R4 forwarding, but R4 terms, R3 passed to R5 of these packets, Just an ordinary IP message). It should be noted here that BGP is different from IGP . IGP is like OSPF . To establish a neighbor relationship, two routers need to be directly connected. BGP does not need to be directly connected because it is a connection established based on TCP .