ccnp route guide

ccnp route guide

Path Route-map test permit 20 match ip address prefix-list 2 set metric 200 Half-life: 15 minutes *>i2.2.2.2/32 Neighbor 4.4.4.4 remote-as 345 Ip community-list 11 permit 100:11 10.1.25.2 Supplementary explanation of the role of the as_set keyword: Bgp default local-preference 500 // Modify the default lp value of the route originating locally The ETHERNET_SNAP frame can be used to transport multiple protocols. Therefore,ccnp route guide, SNAP can be seen as an extension that allows vendors to create their own Ethernet transport protocols. Network R 1.1.1.0/24 is possibly down, 标准Add a standard community-list entry At this time , the policy is used for R4 on R1 , and the route AS_PATH of 10.0 is inserted into the AS number of 100 100 , and R5 is preferably R3 . Why on R5 will select R3 , through experimental results, where R5 received two routes, one from the Federal EBGP neighbors, one from EBGP neighbors, the final preferred EBGP routing neighbors. Multi-hop EBGP SW3 is small), so the interface connected to SW2 on SW4 wins and becomes RP . The behavior of the router is hop-by-hop. Each router along the path to the destination network must have a route to the destination. Shows all routes received from the specified neighbor (a subset of the previous command, shown here is the route remaining after the inbound policy is executed) Note that although the interface configured with portfast is in the no shutdown or the link is up , it will jump to the forwarding state, bypassing the listening and learning , but the interface recommendation must be connected to the router or PC . If the switch is connected, this interface still accepts the calculation result of spanning-tree . If the result of the calculation is block , then the interface will still be blocked . That's why you type this command on the CISCO IOS , IOS will prompt you, saying that it may cause a short bridging loop.