ccnp switch exam blueprint

ccnp switch exam blueprint

? RA(as200) RB(as100) RC(as100) SW3#sh vtp st Configuration command 57 Switch(config-if)# switchport access vlan 10 Switch(config)# interface fast0/2 Switch(config-if)# switchport access vlan 20 100 AS_PATH several commands Y Async Async interface Origin IGP, metric 0, localpref 100, valid, external, multipath , best When a data frame is sent from the Hybrid port, the switch determines whether the attribute of the VLAN on the port is Untag or Tag . If it is Untag , first strip the VLAN tag of the frame and then send it; if it is a Tag , send the frame directly. (Optional) Configuring the security address aging time TCP/IP volume one Note that the main TC while timer is timed on the port, and the BPDU sent by the port will be set by the TC bit , and the BPDU will also be sent out from the root port. Switch(config)# ip routing Next Hop AS number of the AS neighbor On R2 and R3 , there are two OSPF processes. If shown, one is OSPF1 and the other is OSPF2 . Note that this dual process is mainly implemented on the two ASBRs R2 and R3 . If the above is replaced by EIGRP , the phenomenon is the same as RIP , R1 will declare 1.1.1.0 into EIGRP. Timeout Configure abort timeout interval This is not much to say? For PBR , when creating a route-map , it is all permit . No synchronization BGP table version is 10, local router ID is 2.2.2.2 Access switch configuration: Whenever a route is reflected by the reflector, the cluster -ID of the reflector (the cluster) is added to the route's Cluster-list attribute. Ip policy route-map PBR DAI working mechanism RootGuard 10.1.12.2 Sh ip bgp neighbors {address} received-routes There are classes and classless route lookup mode The default priority is 128 , the range is 0-255 , the smaller the better Receiver ( R1 ) 100 Configure EIGRP unicast updates: Both R1 and R2 inject 100.0.1.0 and 100.0.2.0 into BGP using network . Based on agreement Route-map IGP Community number in aa:nn format Add to the existing community Length of the remote-ID type Configuration Example doing what Origin: inherited the worst of origin attributes Type of verification: If there is an EBGP connection between R2 ,ccnp switch exam blueprint, then a routing loop occurs, and R1 and R2 will receive the summary route and accept the routing update. This is because this summary route does not carry any information about AS100 and AS200 . Access-list 11 permit any route-map adv permit 10 match ip address 11 router bgp 12 Ip prefix-list FILTER deny 1.1.1.0/24 ip prefix-list FILTER permit Between routers, routing information is passed, and the distribution list has absolute control over routing information. Therefore, if it is in the direction, by deploying the distribution list, the specific route can be filtered, so that the local routing routing table of the distribution list is changed, and when the local router updates the routing information to the downstream router, the actually updated content is An entry that is affected by the distribution list.