ccnp switch v7 hands on skills exam

ccnp switch v7 hands on skills exam

Ip sla monitor 1 Weight Four types of AS_PATH path attributes Use set excommunity cost x to set in route-map The set command above is used to define the detail route to be injected into the local BGP RIB . The injected prefix can be used Router bgp 100 Command Router ospf 1 (interface) ip load-sharing per-packet Inside the AS , the AS-PATH does not change, and the AS_PATH anti-ring cannot be used , so loops are easy to occur. Roo also received the request, and the request it received from the network segment 172.16.20.0 , and the table found that the network that the route to the host Milne is located ( 172.16.21.0 ) is different from the network that received the arp request packet. And the interface opens the arp proxy,ccnp switch v7 hands on skills exam, so reply to its own interface mac. RFC2082 Summarizing on R3 suppresses all details, but if you only want to release partial details for a particular neighbor, you can use unsuppress-map Bgp confederation identifier 345 This command is used to tell the AS outside the federation . My local AS number is 345. So looking at the above picture, two VLANs are created on the Layer 3 switch : 10 and 20 , and the addresses of the SVIs of the two VLANs are assigned as the user gateways of the respective VLANs , so that the routing table of the switch is There are routes for two VLAN segments. Then, when the two VLANs need to communicate with each other, the user of VLAN 10 will drop the data to his own gateway, that is , the SVI of VLAN 10. After the data arrives at SVI10 , the Layer 3 switch looks up the table and finds that the destination is the network segment where VLAN 20 is located. Throw the data out of VLAN 20 and eventually reach the destination VLAN 20 of the PC .