ccnp route forums

ccnp route forums

The redistribute local route learned from the IGP routing protocol enters BGP , and the MED value inherits the metric in the IGP protocol. 10.1.12.2 In the above figure, R1 and R3 will update routes 1.1.1.0 and 11.11.11.0 to R2 . Of course, by default, R2 is definitely the preferred EIGRP. Root modifies its own configuration BPDU to advertise the entire switching network about topology changes. Root sets the topology change ( TC flag) for a period of time in the configuration BPDU . This time is equal to the forwarding delay + Max. Age , the default is 35S. switchport trunk encapsulation dot1q switchport mode trunk Select 10.1.25.2 as the next hop to the two network segments and load the route into the routing table. So why does R5 choose R2 ? Fa0/20 * 192.168.34.3,ccnp route forums, from 192.168.3.1, 00:09:32 ago, via Serial0/1 Route metric is 20, traffic share count is 1 Based on the above experiment, R1 passes the 11.11.11.0/24 route to R2 , carrying the community value of 100:11 . This value can be matched on R2 using ip community-list , which can be further used in route-map . This community-list goes to set the policy. We now R2 on a community-list to match the 100: 11 , a notification to add no-export the community to the route. Ip prefix-list 10 seq 5 permit 172.16.10.0/24 ip prefix-list 11 seq 5 permit 172.16.11.0/24 route-map test permit 10 Router rip _ For further questions, see RFC 1403 - BGP OSPF Interaction And SW3 on the same case Ip arp inspection limit {rate pps [burst interval seconds ] | none} to sum up 8 Type 1 Manual network through BGP , which originated from IGP , because BGP network must guarantee the network BGP filter Application example Note the changes here: When R2 passes the route of 30.0 to R1 , the seconday AS number is no longer inserted . Principle of ARP protocol (Don't be surprised, the author's record is an afternoon, personally complete the debugging task of nearly 100 switches, of course, there are integrator brothers to help put equipment, add points, labeling). After the switches are debugged, they will be installed in the various computer rooms or weak rooms of the customer site. After all the switches are properly put into operation, they will be put into operation.