ccnp route 2.0

ccnp route 2.0

If BGP routes are passed from EBGP peers description (Optional) Configuring the security address aging time Switchport access vlan 10 interface fast0/24 Switch(config-if)# ip address 192.168.20.254 255.255.255.0 SW1#sh int trunk Only when the update message is sent to another AS when, the BGP router before its AS number append AS_PATH in. This sentence also implies another meaning, that is, if you want to modify the AS_PATH attribute, you must execute the policy on the AS border router. The routing protocols that support TAG are: RIPv2 , EIGRP , OSPF , ISIS , BGP ? After deploying DAI , we can define the trust status of the switch interface: trusted , or untrusted , for trusted ports,ccnp route 2.0, it will not be received. Is 6 , then the type is 802 , default ethernet Ip address 4.4.4.4 255.255.255.0 Create a secondary VLAN : This is the general case, of course, there are two situations, it depends on the specific environment and the specific routing protocol. In the above figure, if both ends of the PC belong to vlan10d , if the fa0/23 port of SW1 will vlan10remove off, then the PC will definitely not be able to communicate. Packet-based load balancing and process switching. Process exchange is for each packet , the router must perform routing table query and interface selection , and then query the data link information. Because each process that determines the routing of packets is independent of each other , all packets destined for the same target network are not forced to use the same interface. In order to open the process exchange function on the interface , you can use the command no ip route-cache under the interface . For IPv6 nothing needs to be done , because by default the feature is turned on.