ccnp route 300-101 topics

ccnp route 300-101 topics

IP CEF turbo control turbo vector RIP-1 only sends RIPv1 updates Neighbor 10.1.12.2 remote-as 200 The shorter the AS-Path, the higher the priority. Ip address 10.1.12.2 255.255.255.0 State BGP current callback state is basically opensent, etc., admin indicates that the neighbor is managed-type shutdown ,ccnp route 300-101 topics, when Sw(config-vlan)#private-vlan association 201,202 PROTOCOL Router bgp 100 Path R3 , R4 , and R5 run OSPF , announcing the three interconnect interfaces and their respective LOOPBACKs. Router(config)# router ospf 1 About PBR Router bgp 1234 Ip address 10.1.12.2 255.255.255.0 Port DAI - Dynamic ARP Inspection Under normal circumstances, the data is preferred to go ip next-hop , that is, go ISP2 ? Show ip bgp injected-path to display When a BGP router sends a route update to its EBGP neighbor, it cannot carry the LP attribute. The LP value of the EBGP route received by the peer is empty. Access-list 1 permit 10.1.1.0 R1#show glbp R1 and R3 , R2, and R5 establish an EBGP neighbor relationship. After " 10.1.20.0 " is passed to R2 , since the updated subnet is consistent with the R2 interface main network, R2 receives the update, and uses the interface mask /23 as the mask of the received RIP subnet, then R2 local loading This RIP route is 10.1.20.0/23 . In fact, the prefix length of the route is wrong. We can configure a secondary address on the R2 interface. In this way, RIP will use the mask of the secondary address (if configured) to receive the route. For example, configure R2 with 10.1.123.222/24 .