ccnp 300-135 passing score

ccnp 300-135 passing score

By default, only when all the alternative route from the same AS different EBGP when neighbors, will be relatively MED ; BGP-Always-Med Compare this command, even if the route can be made from a different AS also MED comparison Maximum-paths 2 [Experiment 4 ] There is a main class network; there is a subnet route (match), the longest match Switch(config)# interface vlan 10 20 !! This is the direct link between R1-R3 Completed in the logical interface 200 300 Route-map test permit 20 match ip address prefix-list 2 set metric 100 The configuration of R2 is similar. After the configuration is complete, the RIP messages are exchanged between R1 and R2 , and the unicast is performed,ccnp 300-135 passing score, so that the PC will not be affected. Unicast update Not the routerID of R1 , because it is not necessary at all). Used to limit the time that the route staying in the routing table has not been updated. 10.1.23.3 from 10.1.23.3 (3.3.3.3) PVST+ has been improved in this respect. PerVLAN means that a VLAN corresponds to a spanning tree. In this way, the switch will calculate the spanning tree based on the VLAN . We can adjust the priority and other related parameters by using a separate VLAN spanning tree, thus affecting Spanning tree calculations ultimately achieve reasonable link bandwidth utilization. For example, in the above figure, there are two VLANs , 10 and 20 on the intranet . Let SW1 become the primary root of VLAN10 (the lowest priority of the whole network switch), SW2 becomes the secondary root of VLAN10 , and SW3 has the highest priority, so we will BLOCK off. SW3 is connected to the upper port of SW3 . In contrast, VLAN 20 is also the most specific adjustment. In this way, the user of VLAN 10 will go out to the left link, the user of VLAN 20 will go to the right, and the link is properly used to achieve load balancing.