ccnp switch sims

ccnp switch sims

A BGP neighbor has an impact only on the router. It can be understood as a weight value. The larger the priority, the higher. The value is in the range 0-65535 . Burst interval , the default is 1s , optional configuration. This is a continuous detection period, used to detect the number of ARP packets in this time period . The default is 1S , so that is, within 1S , if 15 (default) ARP is exceeded , the violation is. This time can be selected from 1-15S. STP uses four parts to solve the Layer 2 loop: The LP field is all there, but it will assign a default value to this route locally, which is 100 , and then pass it to its own IBGP. One point and one asterisk, match all, any 100 i Bgp connected eigrp The beginning of a string <1-99> Community list number (standard) Border Gateway Protocol (BGP) Connected The VTP protocol sends a VTP advertisement on the trunk link through the multicast address 0100-0CCC-CCCC . 2 state changes,ccnp switch sims, last state change 00:07:34 Virtual IP address is 10.1.1.254 We spotted FIG, R1 and R2 between runs RIP to exchange routing information, R2 by RIP learned the R1 release over 192.168.1.0/24 and 2.0 / 24 routing information loaded into the routing table, labeled R & lt . While R2 and R3 and running OSPF , establish OSPF adjacency, R2 also from R3 , by OSPF learned the two routes: 3.0 and 4.0 / 24 , is also loaded into the routing table, labeled O . So, for R2 , it has its own route to the whole network, but inside R2 , we can understand this : it will not change the route learned from RIP .The OSPF route is told to R3 , and the route learned from OSPF is not sent to R1 as a RIP route . For R2 , although there is complete routing information in its own routing table, it is as if there is a gap between the entries of R and O , which cannot be exceeded.