ccnp route 300-101 full course

ccnp route 300-101 full course

After an ARP ACL , if ARP packets are denyed by the ARP ACL , these packets are directly discarded, even in DHCP snooping. Set ip address prefix-list TCAM is the table that is checked when the routing module or router is used for Layer 3 forwarding. Not advertised to any peer 200 Tools Overview Experimental verification The process of processing a VLAN frame by an access port is as follows: The medium to root has the least overhead, so the uplink port is RP . SW3 is different. Since the bandwidth of the interface connected to root is only 10M , the interface connecting SW2 wins as RP . Finally choose DP . I won't go into details. 10.1.13.1 AAAA03 SNAP (fixed value) Flag field LSB = TC MSB = TCA Link type Link types R2#sh cef interface s0/0 policy-statistics input Serial0/0 is up (if_number 4) R3 announces 192.168.1.0 ,ccnp route 300-101 full course, 2.0 , and sets the community attribute of 1.0 to no-adv. Set the timer of STP Due to the existence of the principle of horizontal splitting, BGP requires that the IBGP be fully interconnected within the AS (here, the neighbor command specifies). (The root cause is in KEEPALIVE defaults to 60s . Keepalive timers do not interact in Open messages. How do you set the timer between two BGP neighbors? If the currently configured keepalive timer is less than min ( holdtime ) /3 , the configuration value is taken. Neighbor 3.3.3.3 route-map WT1 in neighbor 5.5.5.5 route-map WT2 in EBGP non-equivalent load balancing Network 172.16.10.0 mask 255.255.255.0 Then the test lines will be powered up for detection. It is found that the 2nd and 3rd lines match, but the matching length of the 2nd line is the longest, so the final result: This port type defined by RSTP is very similar to Portfast . Because these interfaces are used to connect to the host, loops are generally not generated. These ports can skip the LST or LRN to directly transition to the forwarding state. And when these interfaces are up , they will not cause topology changes. In addition, once the edge port receives the BPDU , it immediately loses the feature of the edge port and becomes a normal spanning-tree interface.