ccnp switch 300-115 test

ccnp switch 300-115 test

The following figure is the open message content of the negotiation capability parameter (note the ORF part) Off: EtherChannel not configured on interface Default-information originate Response message and check Route-map test permit 20 match ip address prefix-list 2 set metric 200 The route works, but it is basically not used now, because the uncertainty is too strong) ! Fast Switching R2(config)# router ospf 1 There are 2 forwarders (1 active) 172.16.10.1 , in fact, this IP may be understood as 172.16.0.0/16 within the network, but also in 172.16.10.0/24 within the network, of course, here we can see it, then who is more accurate? It is clear that 172.16.10.0/24 is more accurate, we say that its matching length is longer than 172.16.0.0 . // match AS (100,2 ) and ( 200,2 ) How to judge whether there is arp spoofing in the intranet Virtual-PPP Virtual PPP interface Note that the data exchange process is different for different products. The above process is the result of testing on the CISCO device (server). Both Show run int | include bia can see all the MAC , the first MAC will be used by the spanning tree, which is the CPU 's MAC . Next is the MAC of each Ethernet interface . 3.3.3.3 ( metric 2 ) from 3.3.3.3 (3.3.3.3) 100 The VLAN ID , which is 12 bits long,ccnp switch 300-115 test, indicates the VLAN to which the frame belongs . In VRP , the configurable VLAN ID ranges from 1 to 4094 . Show ip bgp MAC address About the burst-size parameter: 10.1.12.2 3.3.3.3 R1 , R2 , and R3 run RIP , and 1.1.1.0/24 on R1 is not directly announced. On R2 : After the summary command is added with the as-set keyword, the generated summary route can inherit some path attributes of the detailed route, thus avoiding some problems. The rules for inheriting detail attributes from as-set are as follows: 3.3.3.3 After this time has elapsed, the route entry will become 16 hops, marking the unreachable route possibly down . Gateway of last resort is not set This property may not be supported, but even if it is not supported, the route containing the property should be accepted and passed Use strategy in R3 Often used with the portfast feature on the interface for connecting to the host By default, only one BGP process can be started on a single router and can belong to only one AS . DUAL AS allows us to run a secondary AS under the primary AS without terminal BGP connections , thus providing a mechanism for network migration. 10.2.12.1 from 10.2.12.1 (1.1.1.1) 10.1.25.2 It is worth noting that we can manually modify the management distance of the routing protocol in the specific protocol process on R4 , so as to affect the routing of the router itself. For example, on R4 , we will default the administrative distance of OSPF to external routes. 110 , modified to 130 , greater than the RIP management distance of 120 , so that R4 in this environment, for 192.168.1.0 will optimize the RIP route, you can avoid the problem of sub-optimal path and routing feedback .