ccnp switch 300-115 exam dumps

ccnp switch 300-115 exam dumps

Configure Port Security Rate Limiter 10.1.23.2 from 10.1.23.2 (10.1.23.2) Field LocPrf R2 *> 11.11.11.0/24 Network Load distribution: 0 1 0 1 0 1 0 1 0 1 0 1 0 1 0 1 (refcount 1) // to ignore 1.0 of The route originated from the local route (such as the local network or aggregate ), that is, the next hop is 0.0.0.0 ( in the BGP table , the next hop of the route advertised by the current router is 0.0.0.0) Match ip address prefix-list 1 set metric 200 Internal When using Ip default-network to refer to a network locally, if the network number exists in the routing table, the router will designate the network as the default gateway. Ip address 192.168.100.254 255.255.255.0 Route summary In the routing table of R3 , there is only 1.1.1.0 route. The vlan number supported by ISL is 1-1005 (the default is allowed to be normal), 802.1q is 1-4094 (all normal and extended by default), so mapping is required when passing through the 802.1q and ISL trunks . Switch(config)# vlan dot1q tag native Relevant points None It is recognized that the attribute must be followed to describe the next hop router to the destination. Mode Network 10.10.10.0 mask 255.255.255.0 Neighbor 10.1.23.2 remote-as 200 Cisco Express Forwarding We found that both O , O IA or with the FA 's OE2 routes are redistributed into BGP later, these BGP routes Next-hop are they in OSPF the IGP next hop. At the same time, the network segment where the OSPF direct connection port is activated locally will also be injected into BGP . After the injection, Next_Hop is the router (BGP update source IP) . 100 As shown in the figure, R1 and R2 open the LOOPBACK interface with the addresses 1.1.1.1 and 2.2.2.2/24 respectively . That is, a site address, the MAC address, is reserved at this level to identify the only site on the network. Network 10.1.13.1 If R1 turns on auto-summary and network 10.0.0.0 ,ccnp switch 300-115 exam dumps, the subnet will be automatically summarized to R2. Port-Security Overview Background The BGP update package is as follows. You can note that the length of the AS is 2 , which is " 300 , 100 ". Note that this is an ordered list of ASs . / / View command: Show etherchannel 1 summary Redistribution between different OSPF processes Establishing IBGP full interconnection, the configuration is relatively simple, has been involved in the above experiments, let us look at how to achieve through the route reflector. The idea is very simple. We configure R4 as RR and R3 as the client of R4 . In this way, R4 acts as the RR and will reflect the route learned from Client R3 to R5 . It will also learn the route from IBGP neighbor R5 . Reflected to ClientR3 .