ccnp route 300-101 test questions

ccnp route 300-101 test questions

Principle of ARP protocol AS number of the AS neighbor About the rate_in_pps parameter: When an RSTP switch detects a topology change it will: Gateway redundancy technology DTP There can only be one Isolate vlan in a primary VLAN. 5.5.5.5 32768 BGP supports MD5 authentication. To enable MD5 authentication on the TCP connection between BGP peers , use the following command: The GW configuration is as follows: We found that although R4 learned these two prefixes through BGP , it is also valid (with * ), but it is not optimized (not best ,ccnp route 300-101 test questions, no > mark). If it is not optimized, it will not be loaded into the routing table. Then why is this? Note that the next hop of the two routes is 10.1.13.1 , and it is worth noting that the directly connected network segment of 10.1.13.0 is not declared into OSPF by R3 . In other words, R4 goes to the next-hop of the two routes. Unreachable, the next hop is unreachable. Therefore, although the two BGP routes are in the BGP table, they are not best and cannot be loaded into the routing table.