ccnp r&s topics

ccnp r&s topics

On R1 , default information originate is also formed, and R2 and R3 will learn the default route of 0/0 . This command is for RIP Origin IGP, metric 0, localpref 100, valid, internal Access-list 1 permit 1.1.1.0 Comparison principle and configuration considerations In the list, the first AS number (that is , the one that goes to the destination closest to the AS ) Paths: (2 available, best #2, table Default-IP-Routing-Table) Not advertised to any peer 100 Network 192.168.23.2 0.0.0.0 area 0 distribute-list route-map test in 100 i LocPrf After receiving the packet check, R2 finds that this is the IP of the same subnet as the interface that accepts the update package , so accept this update. Therefore, this test, although the interface masks on both sides are different, but can accept each other's updates, and can also ping between 1.1.1.1 and 2.2.2.2 . Configuration Revision 15 Network 192.1.168.2 3 0003.47d9.c8f1 2BB648AB interface-id 584a38f0 END 201 200 100 (Note that in the actual environment, the situation may be quite different). 1,20,30 2 state changes, last state change 00:07:34 Virtual IP address is 10.1.1.254 The secure address learned dynamically through voice vlan will not be converted to sticky mac address. RIP Create secure addresses through dynamic learning, manual configuration, and stciky Knowledge review Router(config)# router ospf 1 The configuration is as follows: 1-4094 Finally ,ccnp r&s topics, select a designated port DP on each segment , sw1 is the root bridge, all interfaces are DP , and finally compare the two interfaces of the direct link between SW2 and SW3 . SW2 receives from the interface SW3 sent BPDU , SW3 also receive SW2 sent BPDU each compare your received BPDU in the bridge ID (also called the comparison transmission bridge ID ), the final SW2 since the MAC address Smaller wins.