ccie collaboration lab topology

ccie collaboration lab topology

4507B#sh module boot system flash0:/cl900-universalk9-mz.SPA.153-3.M.bin Note that this is 0.0.0.0, which is mainly safer. access-list 101 permit ip any any access-list 100 deny ip 192.168.10.0 0.0.0.255 192.168.20.0 0.0.0.255 The above architecture is Cisco's most traditional. Of course,ccie collaboration lab topology , the most stable and classic, and my personal favorite architecture, It’s basically can see such architecture in all books. Sure, the traditional architectural advantage is stability but the shortcomings are also obvious that not suitable for the current situation of big data traffic. Therefore, it is also a backward structure. failover mac address Management0/0 0018.1900.6000 0018.1900.6001 speed auto Disabled The engine is not recognized. There may be hardware problems or software differences. For example, my power supply is 1300W. At this time, this problem occurs. IOS is different, there will be this problem. So in theory, you can PING the public network address such as PING 8.8.8.8 is theoretically achievable. If it is said, it may be an interface problem or an ISP problem. This is also an idea for troubleshooting. For example, if the public network is unreachable, you should first check whether the WNG public network address can be found on the router. Compare the above SN number. Don't make a mistake. This case is very classic. When configuring, I have encountered a lot of problems. I will record it here for your reference. First of all, when you open the chassis, SUP7E comes with License Information for 'WS-X45-SUP7-E' License Level: lanbase Type: Default. No valid license found. Next Reboot license Level: lanbase. Cisco is sending IP BASE's license, there is a white tape inside. Inside is PAK. This must be taken care of when everyone is dismantling. In the event that the second worker was dismantled, the white paper tape was lost.