ccna test questions online

ccna test questions online

Frame-relay map clns 103 broadcast no frame-relay inverse-arp If the payload of the MPLS is an IPv4 packet, load balancing is implemented by hashing the source and destination IP addresses of the IPv4 packet header . Uptime: 10 seconds Selection: reoptimization Or Tunnel Id Type 7 length 12: PHP penultimate jump pop-up mechanism Total Allocated Tspec: ave rate=60000 kbits, burst=1000 bytes, peak rate=60000 kbits RSVP Resv Info: Router-id 5.5.5.5 *Mar 1 00:00:32.759: ISIS-Upd: Building L2 LSP Peer LDP Ident: 4.4.4.4:0; Local LDP Ident 2.2.2.2:0 TCP connection: 4.4.4.4.24940 - 2.2.2.2.646 Detailed information 10.1.23.3 R2 . But why? The reason is that the label assigned by R2 to route 10.1.12.0 is PoP ,ccna test questions online, because 12.0 is the directly connected network segment of R2 , and there is a second-end hop pop-up mechanism. Then this IP packet is R2 to stop the meal , because R2 does not have 6.6.6.6 and 5.5.5.5 routing. How to do? 202 Router-id 1.1.1.1 Area address Further analysis of the metric problem. We focus on 55.55.55.55 , after the basic configuration above, currently in the routing table of R2 10.1.23.3 ! Mpls traffic-eng tunnels ip rsvp bandwidth Additional Knowledge: Label-to-label TTL diffusion behavior in SWAP , PUSH , POP operations Ip address 2.2.2.2 255.255.255.255 Tunnel mpls traffic-eng autoroute announce tunnel mpls traffic-eng priority 7 7 Local binding: tag: 101 Support IP classless routing prefix (support VLSM ) Indicates the available status of a router resource. If the bit is set, it indicates that the router is overloaded. Overloading means that the performance of the router is suppressed due to insufficient CPU and memory resources. It was set overload field that LSP does not diffuse in the network and is calculated by the overload routing the router will not use the LSP .