cisco ccna network simulator

cisco ccna network simulator

1 10.1.46.4 128 msec 152 msec 120 msec Copy this value. Type 2 length 48: It has been verified by experiments. Mpls ip interface fa1/0 Tunnel mpls traffic-eng forwarding-adjacency Show mpls ldp parameters Protocol version: 1 !! The maximum reservable bandwidth is 75M We see that the forwarding aspect of the data is this: Interface loopback1 10.1.24.2 10.1.24.4 There are two types of tunnel priorities: As I said earlier, the NSAP address has an area adddress part that is longer, so when we get an address, how do I know which part of the address corresponds to what? Cisco IOS software from the right explanation NSAP address (here use NSAP of OSI format). First, counting from the right, the first B is NSEL , the left 6B is SystemID , and the rest is AreaID . Level2 area Maximum reservable bandwidth : 9375000 Number of Priority : 8 Tunnel mpls traffic-eng path-option 10 dynamic The routing table of R3 is as follows (omit direct route): In the above figure, we define attribute tags for the two interfaces of R1 . The attribute tag attribute-flags is a 32-bit field. Adding the force keyword will take effect immediately. Otherwise, only when the interface selected as the routeriD is DOWN , the reselection will be performed. Note: The router ID of the LDP neighbor must have reachable routes locally. Net 49.0001.0000.0000.0002.00 LDP ID election is the same as OSPF routerID 4 10.1.45.5 8 msec 8 msec * The PoP : receives downstream air sent by the tag assigned to a specific prefix, the value of this tag is 3 , then the LSR to the downstream LSR transmits the prefix data destined time, he will put up top label ( the POP ) for Forward, note that this time only need to check for this LSR O 1.1.1.1 [110/65537] via 10.1.23.2, 00:09:07, FastEthernet0/0 17 By default, IS-IS of the LSP maximum survival time of 1200s , Reservable Bandwidth[0]: P2P Links: Multiacces Links: R1#traceroute 55.55.55.55 Once the router receives the IIH ,cisco ccna network simulator, it checks the adjacency of the sender of the hello packet. If the adjacency has been established, the adjacency is reset. State: Oper; Msgs sent/rcvd: 13/13; Downstream Up time: 00:03:47 880 Outgoing tag or VC S1 / 0 port hung up, then R2 will no Level2 abutting relationship, that is, R2 and backbone or level2 area disconnected, Network 5.5.5.5 0.0.0.0 area 0 Regular area (non-backbone area) Extending the Number of IS-IS LSP Fragments Beyond the 256 Limit Verify and view Remote binding: tsr: 2.2.2.2:0, tag: 203 R1#traceroute 55.55.55.55 Fa0/0 Therefore, when R2 sends the label packet to the tunnel , the label that is pushed into the outer layer is 304 , and this 304 is obviously allocated by R3 , and is the label assigned by RSVP to the TE tunnel . RFC1195 When the router alarm tag is at the top of the stack, it warns the LSR that the message requires special attention. In this way, the message will not be transmitted through hardware, but will be transmitted through the software process. Once the start of a message is forwarded, the label 1 is first removed, the next LSR in the LFIB label stack the next tag is then performed to find the corresponding label operations ( add, remove, exchange ) , tag 1 will It is added to the top of the label stack and finally forwarded.