ccna security dumps 9tut

ccna security dumps 9tut

Ipv6 unnumbered fast 0/0 tunnel source loopback0 tunnel mode ipv6ip 6to4 0600 – 07FF 2.0 and 3.0 . Now we can by R2 deployment of a distribution list on the distribute-List , so that R2 update to R1 filter out routing information in ! Image 6 !! Sends a distribution update action to a RIPng interface to perform a distribution list. The interface must be in the in/out direction. The interface is optional. If no interface is configured, the interface takes effect. Passive interface Se0/0 ! Exit In addition, if the command is configured when writing: Ipv6 nd prefix 2001:0002::/64 When ISP1 is down, and the GW does not detect it (that is , the interface of GW connected to ISP1 is not DOWN ), the traffic of PC access 100 is still thrown to ISP1 , which is disconnected. OSPF Match x4 set Y In the Stale state, if A wants to send data to B , it can be sent directly, and the entry about B from A is from Stale->Delay , and will wait for the prompt information of the application layer to indicate whether the neighbor is reachable. STALE Probe The polymerizable global unicast address ( Aggregatable Global unicast address ) Image CE1 and CE2 configuration Configuration command Image Interface Serial0/0 ipv6 enable 10.1.12.2 Ipv6 enable Ipv6 rip RIPprocess default-information originate No ipv6 nd suppress-ra 8 8 8 8 Adjust the RIPng process RIP version number: Image R2 re-released the incoming A network segment route and then got up? Then R3 will ignore the route from R1 update. For R3 , go to Image (2) Declare the loop port 1.1.1.1224 RIPv2 supports authentication by changing the field in the RIP message that should normally be the first route entry . In the single update message with authentication , the maximum number of route entries that can be carried is reduced to 24 . Y Border Gateway Protocol (BGP) Connected Image Interface FastEthernet0/0 vrf forwarding cisco ipv6 enable [Note] If the interface is passive , but at the same time the network interface in the routing process, the interface will not attempt to send updates or establish neighbor relationships, but the network segment where it is located will still be declared into the routing process. Route summary When we deploy PBR on an interface , if this interface receives a packet, it will: Ipv6 access-list x enters acl configuration mode Let us look at the above example. In a typical education park network, we often have more than two external network export routes, assuming one for telecommunications and one for education network. Then we generally add a default route to the egress router,ccna security dumps 9tut, pointing to the next hop address of the telecom, in order to allow intranet users to access Internet resources through telecommunication lines . However, if the telecommunications export fails? We can add a default route to the router.