ccna security practice exam

ccna security practice exam

203 Metric problem In R2 opened on loopback interfaces 2.2.2.0/24 , R2 both redistributed RIP into OSPF , they redistribute directly connected into OSPF If multiple next hop IPs are defined , when the local outbound interface associated with the first next hop is DOWN , it automatically switches to the next next-hop . Ipv6 address 2001:34::4/64 interface loopback0 Router bgp 12 One of the ideal solutions is to transform the network topology: [Test 2 ] Image Multi-vendor routing environment Ipv6 unicast-routing 6PE and 6VPE 8 bits Of course, you can also associate the route-map after re-issuing the command and set the tag in the route-map . 10.1.20.0/24 This route is updated by R1 with " 10.1.20.0 ". This is because the subnet mask is consistent with the update interface mask /24 . The v1 update package does not contain a mask. The updated subnet only. number. The IPv6 address that the node must have : If you need to run a dynamic routing protocol between R1 and R3 , you can activate the routing protocol on the tunnel interface. (interface) ip load-sharing per-packet No-rtr-address off-link The two exchange modes , both in principle and in terms of fast switching is very similar ,ccna security practice exam, such as optimum switching actually uses an optimized cache switching (optimumed switching cache), its speed is higher than usual cache is faster .distributed switching mode needs use Versatile Interface card this hardware card , also known as the VIP card. it will save a copy of their own route cache, so that when it is not necessary to wait for a query using a shared system cache (shared system buffer), whether with respect to the fast switching or optimum In terms of switching , it is faster .