ccna boot camp

ccna boot camp

LSP Holdtime The interface address is 2001::1/64 . State Changed: 00:10:04 Format: Phase V Experimental phenomena: Router rip Image EIGRP Interface Serial0/0 ipv6 enable FastEthernet1/0 All options are longer than or equal to 0 The configuration of R1 is as follows: Image Redistribute ospf 1 route-map test RIPv1 Via FE80::FFFF:FE10:2, Serial0/0 RS 133 refers to the use ICMPv6 TYPE133 Code0 the RS message, similar to the other messages. ! Use the same basic packet types, such as Hello , DBD , LSR , LSU , and LSA Image Request the entire routing table: The request message contains a single route with an address family identifier field of 0 (address 0.0.0.0 ) and a metric of 16. The device receiving the request will unicast it back to the requesting address. The entire routing table. or The BGP4+ configuration of R1 is as follows: Ipv6 nat v6v4 pool v6v4-pool 202.101.100.10 202.101.100.20 prefix-length 24 ipv6 nat v6v4 source list ipv6only-network pool v6v4-pool The A record in IPv4 is used to map the host name to a V4 address, and the AAAA resource record maps the host name to an IPv6 address. We can do a test: FastEthernet FastEthernet IEEE 802.3 Header format Route-map defaults to permit , the default serial number is 10 , the serial number is not automatically incremented, and the serial number needs to be specified. Multi-protocol BGP overview Process Switching ( process swap ) In addition,ccna boot camp, if the R1 update 1.0.0.0 to R2 , if R1passive out and R2 interconnect interface, invalid after the expiration, R2 on about the 1.0.0.0 route will Pdown , then R2 can still go to 1.0.0.0 , but will not Pass this route to other neighbors, instead sending non-stop messages. At this time, if the interface of R1 is passived , R2 will continue to receive the update, but it will not resume the route immediately, but will enter the holddown timer until the holddown timer expires before accepting the update of the route.