best ccna dumps 2018

best ccna dumps 2018

Immediate Outgoing interface list: FastEthernet0/0,best ccna dumps 2018, Forward, 00:00:15/00:03:14 We know that the AD value of a static route is 1. The above configuration method actually changes the AD value of the static route to 10 . In this way, we have two default routes, one for the telecom exit, the AD value is the default 1 ; the other points to the education network exit, and the AD value is 10 . Then after 2204 Router(config-router)# distance AD ip-src wildmask acls Address-family ipv6 vrf cisco neighbor 2001:45::5 remote-as 500 C Next hop 10.1.13.3, FastEthernet1/0 valid adjacency AD Router(config)# router eigrp 100 The node has two protocol stacks, IPv4 and IPv6. The IPv6 representation is 2002.c058.6301:: . In your 6to4 configuration, you can use ipv6 roiute ::/0 2002.c058.6301:: to configure the default route. Interface Serial0/0 ipv6 enable OSPF 's neighbor command is not the same as EIGRP . After testing, in the Ethernet environment, directly refer to the neighbor , and still send multicast hello. Image Ipv6 unicast-routing Access-list 1 permit 11.11.11.0 2001:1111::1/128 2001:2::/96 , this 96 -bit prefix is a predefined prefix for NAT-PT operations. The prefix can be customized, but the length must be 96 bits . This predefined prefix is ​​very critical, which is equivalent to pre-defining an IPv6 space for the IPv4 network on the right side of R2 . To give a very simple example, IPv6 single network protocol, if there are PC you want to access IPv4 single-protocol network PC , so a quick visit? What is the destination address? Can not let a IPv6 only the PC to ping an IPv4 address, right? So this /96 pre-defined prefix comes in handy, which can be understood as a predefined IPv6 address space served in the scenario for the IPv4 only network on the right .