ccna security braindumps

ccna security braindumps

Image This way the routing table: Roo also received the request, and the request it received from the network segment 172.16.20.0 , and the table found that the network that the route to the host Milne is located ( 172.16.21.0 ) is different from the network that received the arp request packet. And the interface opens the arp proxy, so reply to its own interface mac. No-rtr-address off-link No bgp default ipv4-unicast neighbor 2001::1 remote-as 12 GRE tunnel basic experiment None Ipv6 unicast-routing Track 1 rtr 1 reachability Install the IPv6 protocol stack Image R1#show ipv6 ospf neighbor detail In the above figure, we inject OSPF routes into RIP . Traditionally, you can only set metrics on all incoming routes . However, with route-map , we can associate a defined one when configuring re-issue commands. A good route-map ,ccna security braindumps, in the route-map , we can create different properties or actions for different routes by creating multiple serial number statements. 2034::4 The IPV4 address configured in the tunnel is the address of the ISATAP router in the CMD command configured on the corresponding ISATAP host . Our experiment demonstrates that the tunnel directly uses the address of fa0/0 . Of course, the tunnel can also have its own IPv4 address, as long as the ISATAP host can reach the IPv4 address. In addition , the IPv6 address of the tunnel , the corresponding prefix is ​​the prefix to be sent to the ISATAP host later . In this experiment, the IPv6 global unicast address of our tunnel uses the prefix +eui-64 configuration mode, here eui-64 In fact, it refers to the special 64bits interface identifier we introduced earlier .