dumps for ccna routing and switching

dumps for ccna routing and switching

The destination IP address of the route can only be the address of the natural network segment. The above command defines the source address allowed to be IPv6 nat , matching with an IPv6 ACL . R3 associates the route-map with the redistribution of the direct route 3.3.3.3/32 , tag#11 , and the route is passed to R2 . On R2 , the redistribution of RIP to OSPF is deployed. After the external route of 3.3.3.3 is injected into OSPF , the tag value is carried by default. The configuration of R2 is similar. After the configuration is complete, the RIP messages are exchanged between R1 and R2 ,dumps for ccna routing and switching, and the unicast is performed, so that the PC will not be affected. 2001:2::2 Ipv6 nat prefix 2001:2::/96 PC1#sh ipv int Fast switching type 1, interface type 18 IP CEF switching enabled Image !! Neighbor 4.4.4.4 is also PE2 , activate VPNv6 support ability In IPv6 , the determination of the link layer address of a node is done using a combination of NS , NA, and the multicast address of the requested node. This ratio IPv4 's ARP Interface ID: After ISATAP is enabled on the host, an ISATAP virtual network card is generated. The virtual network card generates a 64- bit special interface identifier, which is similar to EUI-64 . However, the mechanism is different. It isreserved by 32 bitsreservedfor ISATAP .The 0200:5EFE is combined with the IPv4 address configuredon the host.As shown in the following figure, ifthe IPv4 addressconfigured by the ISATAP hostis 1.1.1.