ccnp switch labs for packet tracer

ccnp switch labs for packet tracer

A After receiving the response, you know B has established a connection with their locally. A also opens up an SAP value to indicate the connection, and sends a confirmation to B to establish the connection. 2bb4c2a1 Note change, replace-as keywords allow R2 to secAS of EBGP when sending routing neighbors,ccnp switch labs for packet tracer, with local-as201 replace real AS200 so replace-as the role of keywords is: Replace with local AS AS Real in the Updates at The EBGP , translate: when the router secondaryAS the EBGP send updated neighbor, with secondaryAS alternative number Pri aS number. CISCO Private Agreement basic configuration Troubleshooting 39 basic configuration IP Address 10.1.13.1 Connection-oriented and reliable data transmission service 15 AS_SET : A list of unordered AS numbers on a path to a particular destination The spanning tree topology in the network is attached to the timer of the root bridge, and the root passes the timer in the BPDU to all switches on the second layer. Ip flow-export forwards the NETFLOW audited packet to the specified device . Interface vlan 10 LP takes the maximum value of LP in the detailed routing Switch(config)# vlan 10 On R4 , there are also redundant links to 100.0.1.0 and 2.0. Both R3 and R5 can reach the two network segments, and finally R4 selects R3 as the next hop to the two network segments. Because in the BGP routing principle, the route preference decision is compared to the BGP routerID , and the RouterID of R3 is smaller than R5 , so R4 is preferably R3 . 2/1 BGP path/bestpath attribute entries using 248 bytes of memory 0 BGP route-map cache entries using 0 bytes of memory As a result, on R2 , the OSPF route 1.1.1.0 in the routing table and the 192.168.12.0 directly connected network segment that is declared into the OSPF process are all announced to RIP , and R1 can learn the two routes through RIP. , as shown in the red bold part below. Configure BPDUs When the switch receives suboptimal BPDUs from other designated switches or root bridges , 802.1D encounters this situation by first ignoring these suboptimal BPDUs . Next Hop .