ccna 200-355 dumps

ccna 200-355 dumps

Set ip next-hop ip1 Set ip next-hop ip2 The IPv4 address obtained by the final PC is as follows: OSPFv3 ( RFC2740 ) Tunnel destination 10.1.23.3 Ip sla monitor responder RIP-1 Only Netflow switching Duplicate address detection ( DAD ) Complete PE1 and PE2 , PE-CE routing protocol configuration, and MP-BGP configuration. Default route Frame-relay map ipv6 2000:12::2 102 broadcast ! Device Configuration You can configure a CISCO router as a 6to4 relay with an arbitrary IPv4 prefix : When ISP1 is down, the interface of GW connected to ISP1 is DOWN , and the traffic of PC access 100 is automatically switched to ISP2. Typical configuration example: Configuration command: In interface mode, you must configure the interfaces on both ends of the link. After the completion, you can show ip rip database to view the routing details. R3 entry: 6000 – 7FFF None Test phenomenon: can ping through ESP head Now let 's do the following configuration on R2 : Redistribution will only perform re-release actions on routes in the routing table. address. In this way, B can actively access A , for example, B to ping 202.101.100.100 , can ping , the process is as follows: !! off-link is related to the L bit, which is defined in RFC2461 . When the optional off-link keyword is configured in CISCO IOS , the L bit is turned off. And if the L bit is turned on (by default), he indicates that the prefix in the RA message is assigned to the local link. Therefore,ccna 200-355 dumps, the node that sends data to the address containing this specified prefix considers the destination to be reachable by the local link.