ccna sp dumps

ccna sp dumps

! Immediate Outgoing interface list: Authentication (16 octets) Ipv6 address 2002:CA65:1703 ::FFFF/64 ipv6 enable 100 Match x4 set Y Interface fast1/0 On R1 , only the summary route 32.0/21 is filtered, and all the detailed routes are released. If a standard ACL is used to match the route, how to write it? After the route-map is called, the matching action will be executed from the smallest sequence number. If the conditions in the sequence number are matched, the set command is executed . If the conditions do not match,ccna sp dumps, the switch to the next sequence number is continued. Match the action. Both R1 and R2 are connected to the 2.2.2.0 network. At this time, R3 goes to ping 2.2.2.2 . Because the static route of the outgoing interface is used, R3 thinks that 2.2.2.0 is a locally connected network, so ARP request is sent , R1 , R2 , can receive the request message, and both respond to the request message (the premise two R1 and R2 are dual-stack routers that connect to both IPv6 and IPv4 networks. Set ip next-hop 11.1.1.2 exit Neighbor 2023::3 remote-as 300 address-family ipv6 Image The cost of the route. Automatic IPv4 compatible tunnel Vrf definition cisco rd 1:1 202.101.100.100 Use a static route to the next hop Router(config-rtr)# poison-reverse R4#sh isis da R4.00-00 l1 detail When the network is normal, the data is forced to go ISP1 , ping 100 remote network data to ISP1 Martian NEXTHOP; 200 ! Image Ipv6 address 2023::2/64 ipv6 nd suppress-ra !! Do not activate RIP , but use re-release Do not use prefix for autoconfiguration Virtual-PPP Virtual PPP interface Ipv6 unnumbered fast 0/0 tunnel source loopback0 tunnel mode ipv6ip 6to4 Wherein 33: 33: FF: 01: 00: 0B is ipv6 destination address FF02 :: 1: FF01: B multicast mapping. Image Tool overview Image Netsh interface ipv6 reset Image !! ISP1 , ISP2 and GW all need to open CDP Must be a zero field. The configuration of R2 is as follows: 8 8 8 8 RIPng for IPv6 Image The header carries optional information specific to the destination of the packet, such as for exchanging registration information between the mobile node and the home agent, moving In an IPv6 multicast address, there is a special multicast address called Solicited-node address (the requested node multicast address ) . The Solicited-node address is a special purpose address. Mainly used for duplicate address detection ( the DAD ) and alternative IPv4 in the ARP . The Solicited-node address consists of the prefix FF02::1:FF00:0 / 104 and the last 24 bits of the ipv6 unicast address .