ccna dumps pdf 200-125

ccna dumps pdf 200-125

The IPv4 public network address obtained by A is 132.214.1.10 , and B is 206.123.31.200 . 0000 0000 xxxx xxxx Track 1 rtr 1 reachability Experimental needs The configuration of R4 is as follows: Feature overview The meaning of this command here is that only 1.1.1.0 is allowed to go out of the route redistributed from the RIP routing protocol (to OSPF , there is no direction, as long as the interface is running OSPF ) The dual-stack host uses HTTP to access the tunneling proxy through IPv4 . This dual-stack host may be an end user that fills in a web page. DAD ( Duplicate Address Detection ) Neighbor 2001::1 update-source loopback 0 exit-address-family The configuration of R1 is as follows: Neighbor FE80::CE01:8FF:FED8:10 activate Neighbor 2.2.2.2 update-source Loopback0 3 : MD5 verification. ::1 test.com AFI (Address family identifier) Image Image Access-list 1 permit 1.1.1.0 Pop tag Neighbor 2001:12::1 remote-as 100 The comparison principle of OE2 is first compared to the external metric of OE2 . If they are equal, further comparison of the internal metric is the metric to the ASBR . Test phenomenon: unable to ping . Cc01.0cf0.0000 Image Neighbor FE80::CE01:8FF:FED8:10 activate ! Modify the timer. The default update 30S ,ccna dumps pdf 200-125, expire is the default timeout of 180S . Image Update it; however, it does not send its secondary address 11.0.0.0 segment from fast0/0 to R1 (unless the split horizon is turned off). Ipv6 router ospf 1 router-id 2.2.2.2 Network 4.4.4.4 0.0.0.0 area 0 Network 192.168.10.0 0.0.0.255 area 1 Image Technical overview Interface Serial0/1 ipv6 enable The so-called seed metric refers to when I use a route to re-publish from an external routing protocol to this routing protocol, if the metric of the route is not manually specified , the default metric is used . Look at the following table (the following table is a recognized default value that can be modified using the default-metric in the routing process ): Router(config-if)# ipv6 rip xxx metric-offset ? Isis circuit-type level-1 interface Serial0/1 This RS message via IPv4 tunneling, the outer layer is the IPv4 header, source address ISATAP the IPv4 address 1.1.1.1 , the destination address is 2.2.2.2 , which is ISATAP of IPv4 addresses. The IPv4 header is wrapped with IPv6 packets. The source address is the ISATAP host. 202 UDP No bgp default ipv4-unicast bgp log-neighbor-changes Cur Hop Limit : indicates that when the PC constructs an IPv6 address using the prefix advertised by the RA , the PC sends Access-list 1 permit 10.1.1.0 0.0.0.255 route-map test permit 10 R2(config)# access-list 1 deny 192.168.3.0 R2(config)# access-list 1 permit any R2(config)# router ospf 1 In IPv6 , the options in v4 were moved to the extended header. An IPv6 packet may include zero or more extension headers. When multiple extension headers are used, the extension header after the extension header is indicated by the Nexthead field of the previous header. With the extended header, the intermediate router does not need to deal with every possible option, which increases the speed at which the router processes packets and improves its forwarding performance. At the end of the extended header chain is the payload.