cisco ccna exam prep

cisco ccna exam prep

Ipv6 address 2001:1111::1/64 ipv6 ospf 1 area 0 Route-map test permit/deny 10 2.2.2.2/32, version 55, epoch 0, per-destination sharing 0 packets, 0 bytes The key configuration of R3 : ! Version In R2 on a simple look: 2. Pass the RIP update with an unnumbered address ( invalid source ) There is an address pool on R1 . If R2 wants to use the address pool of R1 ( IPv6 DHCPserver ) to allocate it to users on its intranet, then you can make The first 8 bits of the route must be exactly matched with the first 8 bits of 172.0.0.0 . The other bits do not care, and the mask length must be greater than 24. Note that here The configuration of R2 is as follows (basic configuration and OSPFv3 ): Extended header IP Redistribute connected route-map test no synchronization Re-advertise routes between different OSPF processes Port number 521 Exit-address-family Now, change the interface ipv6 MTU of the F1/0 port of R2 to 1400 bytes (the default interface IPv6 MTU in the above figure is 1500 bytes): Neighbor state If multiple candidate default routes are specified using ip default-network , then the lowest AD will become the default route and set as the default gateway ( gate of last resort ). If AD is equal,cisco ccna exam prep, then show ip route The first one is displayed as the default gateway. If both ip defaut-network and ip route 0.0.0.0 0.0.0.