ccna 200-125 dumps questions

ccna 200-125 dumps questions

2002: ce7b:1fc8:1::1 performs a recursive lookup of the routing table and finds that it is to be thrown out from the tunnel1 interface, so that the original IPv6 data is pressed onto the new IPv4 tunnel header, and the source address is the IPv4 source address of the tunnel 132.214. 1.10 , the destination address is 206.123.31.200 . This packet is just like R2 . Image Ipv6 ospf 100 area 1 interface serial0/1 NEXT_HOP : Indicates an IPv6 address, or an aggregatable global unicast address, or an aggregatable global unicast address and its next hop local link address. Area Address(es): 49.0002 SNPA: *HDLC* Exit-address-family Version Image Experimental test Bgp router-id 3.3.3.3 Identify the type of message: Neighbor FE80::CE01:8FF:FED8:10 password cisco neighbor FE80::CE01:8FF:FED8:10 activate redistribute connected route-map test Image Network <0-4294967295> 32-bit tag value ... partially omitted ... Ip default-network Ipv6 address 2001:45::4/64 ipv6 ospf 1 area 0 //Get out a summary route instead of the default route Input conditions: length < ge-value < le-value <= 32 Router(config-router)# router-id xxxx 1. Configure IPv6 IS-iS on the GRE tunnel. Type echo protocol ipIcmpEcho 10.1.1.2 source-ipaddr 10.1.1.1 frequency 10 ! Route-map features BGP R3 will initiate a Register to the RP and the multicast data will be sent to R1 . At this time, the multicast data is actually going to R1, that is, to the receiver, but in fact, some more complicated things are still happening underneath. R1 receipt Register Thereafter, there will be formed the source wishes SPT , so it asks R2 issued a SPT of the join message, R2 after receiving own Fa0 / 0 is added to the corresponding port multicast table entry outgoing interface list of . However, since the multicast data is always sent from the Fa1/0 port of R2 (because when we tested, the specified outgoing interface is Fa1/0 ), R1 continuously receives the multicast data sent by R3 and encapsulates the multicast data. Register , but did not receive alongSPT passed down the multicast data, therefore, Rl is not to R3 transmits Register-STOP ,ccna 200-125 dumps questions, R3 registration process can be repeated, the multicast data will always be encapsulated in Register transmitted message Rl .