ccna 200-125 dumps ete

ccna 200-125 dumps ete

Ipv6 address 2004:1:1::1/64 ipv6 address 2004:1:2::1/64 meaning Ethernet Default route Image <0-4294967295> 32-bit tag value 010x xxxx xxxx xxxx [Experiment 6 ] There are subnet routes, the subnet route prefix length is different (matching and mismatching), and the matching route is taken. For example, the public network address of R1 is: 202.101.12.1 , then the corresponding 6to4 address space is: 2002:CA65:0C01::/48 Default router is FE80::CE00:1AFF:FEC4:10 on FastEthernet0/0 ! PC (using router emulation) uses stateless auto get address: ipv6 address autoconfig default R Do not use prefix for onlink determination Interface tunnel1 Ipv6 enable Immediate Outgoing interface list: Then the received route becomes 10.1.20.0/24 and the mask is correct . The GRE tunnel is a well-known standard tunneling technology that guarantees a stable and secure end-to-end link. Ipv6 nd ns-interval !! is used to set the interval of the neighbor request message. The default is 1000ms or 1S. Image Ipv nd prefix 2012::/64 no-advertise Router(config-router)# distance AD ip-src wildmask acls ! 5 : local site range; Router bgp 300 The neighbor request has been sent to the destination node's request multicast address, but no neighbor notification has been received. 2000 – 3FFF Image 10.1.12.2 Router ospf 1 The configuration of CE2 is as follows: 301 In R2 on a simple look: The configuration of PE1 is as follows: Subnet router anycast address: UNICAST_PREFIX : 0:0:0:0 RIP Version 2 Carrying Additional Information Length,ccna 200-125 dumps ete, or mask length. When paired with the above ACL , some students will even write Router bgp 300 Image The IPv4 and IPv6 address plans are as shown in the figure above. RIP update behavior ! For example, R1 redistributed into direct on the OSPF , with out distribution list can be filtered out direction 1.1.1.0 this external routes. But R1 redistributed incoming routing, if R2 with the out distribution lists direction tried to block R3 accepted routes or LSA , you can not, because this is not a local external routes originating. Fast switching is superior to process switching, it uses a route cache ( route cache ) for storing information about a stream of data (Flow) specific information , Redis static route-map test First, all routers in the site continue to advertise the current prefix (old prefix), but the valid and preferred lifetime are reduced to a value close to 0 , then the router starts advertising new prefixes on the local link, so each local There are at least two prefixes on the link. When the old prefix is ​​completely retired (the lifetime has passed), the router advertisement message only includes the new prefix.