ccna wireless dumps free

ccna wireless dumps free

FastEthernet0/0 1400 Image Default 30s ,ccna wireless dumps free, RIP update cycle Ipv6 dhcp pool DHCP-pool Ip route 1.1.1.0 255.255.255.0 serial 0/0 FF01::1 ; FF02::1 The default is 6 update cycles, which is 180s . The route entry tag when an entry with a larger hop count is received ! The AD value of 11.11.11.0/24 is adjusted to be larger than OSPF , for example 130 . So the configuration is as follows: Bgp connected eigrp Y 6 Image ! Solution: Modify the routing protocol management distance If there is an NA response or an application layer prompt message in Delay_First_Probe_Time (default 5S ) (for example, if I send an ICMP packet to the peer and the peer replies to my ICMP , then the upper layer is reachable), then Delay->Reachable , if No application layer prompt information, Delay->Probe Ipv nd prefix 2012::/64 no-advertise Used to limit the time that the route staying in the routing table has not been updated. Requested node multicast address corresponding to each unicast and anycast address used Update timer update timer If it is unreachable, the suppression timer is started at the same time. If the timer expires, the same neighbor still advertises the Flags 4bits , 0000 : permanently assigned or well known ; 0001 : temporary Router(config-rtr)# distance x Neighbor 2001:12::1 remote-as 100 IPv6 basic application Valid lifetime ( ! Valid Lifetime ) PS : When the same router has two static routes to the same destination, the outbound interface and the next hop are used respectively. The two routes are load balanced (because the AD value and the metric value are equal). The static route configured by the outbound interface is imported into the routing table as a directly connected network. For details, see the static routing part of this document.